On Sat, May 12, 2007 at 03:58:17PM -0700, Joshua Andrews wrote:
After installing kernel 2.6.21-1.3149.fc7 the controller still does
not
work.
The error message has changed.
ACPI: PCI Interrupt 0000:00:13.0[A] -> GSI 18 (level, low) -> IRQ 19
ata3: PATA max UDMA/66 cmd 0x0001b400 ctl 0x0001b802 bmdma 0x0001bc00 irq 19
scsi2 : pata_hpt366
ata3: port disabled. ignoring.
piix4_smbus 0000:00:07.3: Found 0000:00:07.3 device
ACPI: PCI Interrupt 0000:00:13.1[B] -> GSI 18 (level, low) -> IRQ 19
ata4: PATA max UDMA/66 cmd 0x0001c000 ctl 0x0001c402 bmdma 0x0001c800 irq 19
scsi3 : pata_hpt366
ata4: port disabled. ignoring.
And the PCI dump agrees with this - your HPT366 controller is disabled. The
following might help but from all the code/docs I have something has disabled
that port.
There is a matching upstream report of this (but with the old IDE driver which
was corrected to test these bits) so it doesn't appear unique but a problem
with a few boxes.
Alan
--- drivers/ata/pata_hpt366.c~ 2007-05-13 00:14:51.971506056 +0100
+++ drivers/ata/pata_hpt366.c 2007-05-13 00:14:51.972505904 +0100
@@ -227,10 +227,10 @@
{ 0x54, 1, 0x04, 0x04 }
};
struct pci_dev *pdev = to_pci_dev(ap->host->dev);
-
+#if 0
if (!pci_test_config_bits(pdev, &hpt36x_enable_bits[ap->port_no]))
return -ENOENT;
-
+#endif
return ata_std_prereset(ap, deadline);
}