<div dir="ltr"><br><div class="gmail_extra"><br><div class="gmail_quote">2014-12-20 3:29 GMT+02:00 Andy Green <span dir="ltr"><<a href="mailto:andy@warmcat.com" target="_blank">andy@warmcat.com</a>></span>:<br><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><div class=""><div class="h5"><br>
<br>
</div></div>Is it really idle? Something seems to be making him abnormally hot.<br>
<br>
Any clues in top or cat /proc/interrupts?<br></blockquote><div><br></div><div>I think about that. I belive it is not related to interrupts or overload, because the system responce is very good. Also htop reported just a few percent load on both cores. Which is OK for XFCE, browser and several Terminals.<br> I will make new logs soon.<br></div><div> <br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><span class="">
</span>It's be nice if there was some interrupt going nuts we could see in /proc/interrupts making execessive latency.<br></blockquote><div><br>I will also try detach any external hardware, once activate ssh.<br></div><div><br> </div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">
<br>
How about the U-Boot / MLO pieces? They have nasty deps like gpu clock state and default GPIO state.<br>
<br></blockquote><div><br></div><div>I didn't understand U-Boot and MLO yet. But loader/configuration is stock Fedora one.<br></div><div>It happen on two clean F21 installations on different flash cards.<br></div><div>Before Fedora I tested Arch Linux Arm. Could that changed some firmware configuration? Is it a way to reset?<br></div><div> </div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">
If the only clue is excess heat it can be something like a contended SoC GPIO.<br>
<br>
-Andy<br>
<span class=""></span><br>
</blockquote></div><br></div><div class="gmail_extra">I doubt that too. I didn't used GPIO's and board is as clean as new. Unless it is defective.<br><br></div><div class="gmail_extra">My guess for now is that software somehow toggle wrong voltage/frequency. Is it a way to directly check that?<br></div><div class="gmail_extra"><br></div><div class="gmail_extra">Maybe I will test with some old software that panda advertises, to see what will happen than. But don't know when, because it can take some more time.<br></div></div>