Fedora 20 Update: cura-13.11.2-1.fc20

[updates at fedoraproject.org]

--------------------------------------------------------------------------------
Fedora Update Notification
FEDORA-2013-23447
2013-12-16 06:31:03
--------------------------------------------------------------------------------

Name        : cura
Product     : Fedora 20
Version     : 13.11.2
Release     : 1.fc20
URL         : http://daid.github.com/Cura/
Summary     : 3D printer control software
Description :
Cura is a project which aims to be an single software solution for 3D printing.
While it is developed to be used with the Ultimaker 3D printer, it can be used
with other RepRap based designs.

Cura helps you to setup an Ultimaker, shows your 3D model, allows for scaling /
positioning, can slice the model to G-Code, with sane editable configuration
settings and send this G-Code to the 3D printer for printing.

--------------------------------------------------------------------------------
Update Information:

cura update 13.11.2
* Adjusted the gantry height to 55mm for the Ultimaker, as 60mm was 3mm to high for the default setup with an V2 hotend.
* Added disallowed zones for UM2
* Added ooze-shield for dual-color printing
* Added wipe tower for dual-extrusion
* Added no-go zones for UM2 glass clips
* Added imageToMesh tool to load images as 3D height maps
* Fixed Z support distance when using "everywhere" support.
* Updated to new version of clipper to fix rare slicing bugs that resulted in odd paths.
* Fixed "Reset profile" so it no longer resets the machine settings.
* Updated support material so support is smoother and has less small sections which are hard to remove.
* Fixed start-gcode when using dual-support material
* Change how the fan is handled on lower layer to improve UM2 printing.
* Fix that retraction is enabled when selecting UM2 or RepRap.
* Scale down very large models, or scale up very tiny models automagicly.
* Fixed skirt and brim to go around the support instead of under it.
* Added spiralize mode

Ultimaker2 - Firmware update - 13.11-2
* Fixed UM2 build volume offset so that you do not print off the glass plate.
* Slightly tweaked the filament change procedure so there is less chance of a blob staying behind.
* Slightly tweaked the SD-Card error problems.
* Added LED settings to Tune menu
* Start heating the nozzles when the bed is nearing its final temperature, so the nozzles do not sit hot.
* Make sure all commands are finished before starting a print or changing material. This could cause issues when you where too fast.
* Fixed SD-Card read error
* Added feature to store your own material presets
* Fixed the 280C ABS problem, causing a temperature sensor error
--------------------------------------------------------------------------------
ChangeLog:

* Sat Dec 14 2013 Miro Hrončok <mhroncok at redhat.com> - 13.11.2-1
- New version 13.11.2
--------------------------------------------------------------------------------

This update can be installed with the "yum" update program.  Use 
su -c 'yum update cura' at the command line.
For more information, refer to "Managing Software with yum",
available at http://docs.fedoraproject.org/yum/.

All packages are signed with the Fedora Project GPG key.  More details on the
GPG keys used by the Fedora Project can be found at
https://fedoraproject.org/keys
--------------------------------------------------------------------------------