Failed to load SELinux policy ????

[Phil Meyer]

On 04/04/2011 09:14 AM, Brian Millett wrote:
> Ok, so I've never had selinux enabled.  The config is
>
> __BEGIN__
> # This file controls the state of SELinux on the system.
> # SELINUX= can take one of these three values:
> #	enforcing - SELinux security policy is enforced.
> #	permissive - SELinux prints warnings instead of enforcing.
> #	disabled - SELinux is fully disabled.
> SELINUX=disabled
> # SELINUXTYPE= type of policy in use. Possible values are:
> #	targeted - Only targeted network daemons are protected.
> #	strict - Full SELinux protection.
> SELINUXTYPE=targeted
> __END__
>
> I've got selinux=0 as a boot arg,
>
> so why am I getting this message at boot time??
>
> "Failed to load SELinux policy."
>
> Just started after the update to
>
> Updated: selinux-policy-3.9.16-10.fc15.noarch
> Updated: selinux-policy-targeted-3.9.16-10.fc15.noarch
>
>
> thanks.

Seeing the same thing here.  Had to add selinux=0 to the boot line to 
get it to boot at all.