dracut kernel-panci
Denis Arnaud
denis.arnaud_fedora at m4x.org
Sun May 27 12:07:18 UTC 2012
Hi Frank,
On 24/05/12 14:08 UTC, Frank Murphy wrote:
> # dracut initramfs-3.5.0-0.rc0.git3.1.fc18.x86_64
> 3.5.0-0.rc0.git3.1.fc18.x86_64
> F: installkernel failed in module multipat
>
> # rpm -qa | grep multipath
> device-mapper-multipath-libs-0.4.9-22.fc18.x86_64
> device-mapper-multipath-0.4.9-22.fc18.x86_64
I had the same problem, but just on my 32bit Rawhide. Indeed, those
two packages (device-mapper-multipath and
device-mapper-multipath-libs) were installed on the x86_64 Rawhide.
So, the solution/work-around is simple:
# rpm -e device-mapper-multipath-libs-0.4.9-22.fc18.x86_64
device-mapper-multipath-0.4.9-22.fc18.x86_64
# dracut
That time, the initramfs should be created. Just check that it has
been created. For instance:
# ls -l /boot/initramfs-3.5.0-0.rc0.git3.1.fc18.x86_64.img
Then, of course, you have to update the Grub2 configuration, by adding
the following lines to /etc/grub2.cfg:
<tab>echo 'Loading initial ramdisk ...'
<tab>initrd /initramfs-3.5.0-0.rc0.git3.1.fc18.x86_64.img
Note that, if you do not have a dedicated /boot partition, you should add
the /boot prefix in the above line.
That's basically it.
Regards
Denis
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.fedoraproject.org/pipermail/test/attachments/20120527/baf191e2/attachment.html>
More information about the test
mailing list