Routing not working

[Tom Horsley]

On Wed, 01 Jun 2011 11:07:54 -0400
Genes MailLists wrote:

>  In the meantime can you provide the outputs of what I suggested
> previously for the F15 system. Are you seeing any AVC's by the way ?

I got the info from f15, but I also found when I rebooted
that the wi-fi on the phone couldn't connect this time because
the dhcpd died for no obvious reason after my script started
it. Also, I'm not using any ipv6 on f14 or f15 (as far as I know).

Anyway, other than substituting em1 for eth0, the output I gathered
on f15 looked identical to the output on f14:

ifconfig says:

em1       Link encap:Ethernet  HWaddr 00:1E:4F:9A:D6:E5  
          inet addr:10.134.30.143  Bcast:10.134.30.255  Mask:255.255.255.0
          inet6 addr: fe80::21e:4fff:fe9a:d6e5/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:2468 errors:0 dropped:0 overruns:0 frame:0
          TX packets:700 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:218060 (212.9 KiB)  TX bytes:76510 (74.7 KiB)
          Interrupt:21 Memory:febe0000-fec00000 

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:1081 errors:0 dropped:0 overruns:0 frame:0
          TX packets:1081 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:83988 (82.0 KiB)  TX bytes:83988 (82.0 KiB)

mon.wlan0 Link encap:UNSPEC  HWaddr 94-44-52-45-F3-3A-E0-F1-00-00-00-00-00-00-00-00  
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:78 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:6855 (6.6 KiB)  TX bytes:0 (0.0 b)

wlan0     Link encap:Ethernet  HWaddr 94:44:52:45:F3:3A  
          inet addr:192.168.9.1  Bcast:192.168.9.255  Mask:255.255.255.0
          inet6 addr: fe80::9644:52ff:fe45:f33a/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:55 errors:0 dropped:4 overruns:0 frame:0
          TX packets:51 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:13720 (13.3 KiB)  TX bytes:13844 (13.5 KiB)

Here's iwconfig:

lo        no wireless extensions.

em1       no wireless extensions.

wlan0     IEEE 802.11bg  Mode:Master  Frequency:2.462 GHz  Tx-Power=27 dBm   
          Retry  long limit:7   RTS thr:off   Fragment thr:off
          Power Management:on
          
mon.wlan0  IEEE 802.11bg  Mode:Monitor  Tx-Power=27 dBm   
          Retry  long limit:7   RTS thr:off   Fragment thr:off
          Power Management:off

Here's ip route:

10.134.30.0/24 dev em1  proto kernel  scope link  src 10.134.30.143 
192.168.9.0/24 dev wlan0  proto kernel  scope link  src 192.168.9.1 
169.254.0.0/16 dev em1  scope link  metric 1002 
default via 10.134.30.196 dev em1 

Here's ip addr show:

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 16436 qdisc noqueue state UNKNOWN 
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
    inet6 ::1/128 scope host 
       valid_lft forever preferred_lft forever
2: em1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP qlen 1000
    link/ether 00:1e:4f:9a:d6:e5 brd ff:ff:ff:ff:ff:ff
    inet 10.134.30.143/24 brd 10.134.30.255 scope global em1
    inet6 fe80::21e:4fff:fe9a:d6e5/64 scope link 
       valid_lft forever preferred_lft forever
3: wlan0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP qlen 1000
    link/ether 94:44:52:45:f3:3a brd ff:ff:ff:ff:ff:ff
    inet 192.168.9.1/24 brd 192.168.9.255 scope global wlan0
    inet6 fe80::9644:52ff:fe45:f33a/64 scope link 
       valid_lft forever preferred_lft forever
4: mon.wlan0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UNKNOWN qlen 1000
    link/ieee802.11/radiotap 94:44:52:45:f3:3a brd ff:ff:ff:ff:ff:ff

Here's /proc/sys/net/ipv4/ip_forward

1

I'm starting to wonder if the ralink driver it is using is
just flaky on f15.