e1000e problem in Fedora 15

[Amit Karpe]

Hi,
We having new HP Z820 workstation. Which have Intel 82574L &
82579LM gigabit network card.
While booting in Fedora 15   it just stuck. Following are output in Fedora
17 (where system boot with success.)
[root at localhost ldap_newhp]# lspci -nn | grep -i eth
00:19.0 Ethernet controller [0200]: Intel Corporation 82579LM Gigabit
Network Connection [8086:1502] (rev 05)
01:00.0 Ethernet controller [0200]: Intel Corporation 82574L Gigabit
Network Connection [8086:10d3]

Few lines from dmesg

[ 1633.233297] e1000e 0000:04:00.0: irq 73 for MSI/MSI-X
[ 1633.284094] e1000e 0000:04:00.0: irq 73 for MSI/MSI-X
[ 1633.285079] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 1642.265283] e1000e 0000:04:00.0: irq 73 for MSI/MSI-X
[ 1642.316094] e1000e 0000:04:00.0: irq 73 for MSI/MSI-X
[ 1642.317556] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 1647.280547] e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow
Control: RX/TX
[ 1647.285563] e1000e 0000:04:00.0: eth0: 10/100 speed: disabling TSO
[ 1647.291153] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[ 1657.802008] eth0: no IPv6 routers present


In F15 pass ACPI=off to kernel then it boot without problem, but them
Ethernet card are not able to configure.

Any idea ?
-- 
Regards
Amit Karpe.
http://www.amitkarpe.com/
http://news.karpe.net.in/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.fedoraproject.org/pipermail/users/attachments/20130222/00d43a2d/attachment.html>