<br><font size=2><tt>&gt;&gt; I've loaded FC2 on an HP DL140 with no problems,
except that FC2 did not <br>
&gt;&gt; recognize the onboard NICs. &nbsp;During boot I have noticed the
following <br>
&gt;&gt; messages:<br>
&gt;&gt; <br>
&gt;&gt; Agpgart: Unsupported Serverworks Chipset (Device ID: 0017)<br>
&gt;&gt; Agpgart: Unsupported Serverworks Chipset (Device ID: 0017)<br>
&gt;&gt; Agpgart: Unsupported Serverworks Chipset (Device ID: 0227)<br>
&gt;&gt; Agpgart: Unsupported Serverworks Chipset (Device ID: 0110)<br>
&gt;&gt; Agpgart: Unsupported Serverworks Chipset (Device ID: 0110)<br>
&gt;&gt; <br>
&gt;&gt; I loaded a clean FC2 (2.6.5-1.358smp) distribution with all defaults.
&nbsp;The <br>
&gt;&gt; system comes up and seems to run just fine, but I just can't get
it to <br>
&gt;&gt; recognize the NICs. &nbsp;I have searched the web and the Fedora
Archives for <br>
&gt;&gt; similar problems without any positive results. &nbsp;Any help
is greatly <br>
&gt;&gt; appreciated.<br>
&gt;<br>
&gt;I shouldn't think that the AGP GART (only of any use for accelerated
3D<br>
&gt;graphics) affects your NICs. Does lspci show them?<br>
</tt></font>
<br><font size=2><tt>lspci does show them with the following information:</tt></font>
<br>
<br><font size=2><tt>00:10.0 Host Bridge: ServerWorks CIOB-E I/O bridge
with Gigabit Ethernet (Rev 12)</tt></font>
<br><font size=2><tt>00:10.2 Host Bridge: ServerWorks CIOB-E I/O bridge
with Gigabit Ethernet (Rev 12)</tt></font>
<br>