Hello all,<br /><br />I am running fedora 12 and have two bonded
interfaces. Everything works fine if I manually start my bonded
interface (bond0). It also works fine if I put (ifup bond0) in
/etc/rc.d/rc.local. However, it refuses to start on boot otherwise
and rc.local is kinda late in the boot sequence. Things that require
the network to be running become very unhappy. <br /><br />NM is not
running so that can not be interfering. I have three systems all
using Intel NICs but otherwise different hardware. They are all
having this issue. What am I missing (ID 10 T error probably)?
As always, any help would be appreciated.<br /><br />Here is some system
information:<br /><br /># chkconfig|grep Network<br />NetworkManager
0:off 1:off 2:off 3:off
4:off 5:off 6:off<br /><br /># uname -a<br />Linux
test 2.6.32.19-163.fc12.x86_64 #1 SMP Wed Aug 18 11:38:54 UTC 2010 x86_64
x86_64 x86_64 GNU/Linux<br /><br /># cat /etc/modprobe.conf<br />alias
bond0 bonding<br />options bond0 miimon=100 mode=4<br /><br /># cat
ifcfg-bond0<br />DEVICE=bond0<br />IPADDR=10.64.236.67<br
/>NETMASK=255.255.255.0<br />NETWORK=10.64.236.0<br
/>BROADCAST=10.64.236.255<br />ONBOOT=yes<br />BOOTPROTO=none<br
/>USERCTL=no<br />BONDING_OPTS="miimon=100 mode=4"<br
/>NM_CONTROLLED=no<br />GATEWAY=10.64.236.1<br />TYPE=Ethernet<br
/>IPV6INIT=no<br />NAME="system bond0"<br
/>IPV4_FAILURE_FATAL=yes<br /><br /># cat ifcfg-eth0<br /># Intel
Corporation 82546EB Gigabit Ethernet Controller (Copper)<br
/>DEVICE=eth0<br />USERCTL=no<br />ONBOOT=yes<br />MASTER=bond0<br
/>SLAVE=yes<br />BOOTPROTO=none<br />HWADDR=00:14:4F:78:4D:64<br
/>TYPE=Ethernet<br />NM_CONTROLLED=no<br />IPV6INIT=no<br
/>NAME="system eth0"<br
/>UUID=5fb06bd0-0bb0-7ffb-45f1-d6edd65f3e03<br /><br /># cat ifcfg-eth1<br
/># Intel Corporation 82546EB Gigabit Ethernet Controller (Copper)<br
/>DEVICE=eth1<br />USERCTL=no<br />ONBOOT=yes<br />MASTER=bond0<br
/>SLAVE=yes<br />BOOTPROTO=none<br />HWADDR=00:14:4F:78:4D:65<br
/>NM_CONTROLLED=no<br />TYPE=Ethernet<br />IPV6INIT=no<br
/>NAME="system eth1"<br /><br /><br /># ifconfig<br />
bond0 Link encap:Ethernet HWaddr
00:14:4F:78:4D:64<br />
inet
addr:10.64.236.67 Bcast:10.64.236.255 Mask:255.255.255.0<br />
inet6 addr:
fe80::214:4fff:fe78:4d64/64 Scope:Link<br />
UP BROADCAST
RUNNING MASTER MULTICAST MTU:1500 Metric:1<br />
RX packets:1097
errors:0 dropped:0 overruns:0 frame:0<br />
TX packets:658
errors:0 dropped:0 overruns:0 carrier:0<br />
collisions:0
txqueuelen:0<br />
RX bytes:141477 (138.1 KiB) TX bytes:137257 (134.0 KiB)<br /> <br />
eth0 Link encap:Ethernet HWaddr
00:14:4F:78:4D:64<br />
UP BROADCAST
RUNNING SLAVE MULTICAST MTU:1500 Metric:1<br />
RX packets:582
errors:0 dropped:0 overruns:0 frame:0<br />
TX packets:271
errors:0 dropped:0 overruns:0 carrier:0<br />
collisions:0
txqueuelen:1000<br />
RX bytes:77525
(75.7 KiB) TX bytes:56514 (55.1 KiB)<br /> <br />
eth1 Link encap:Ethernet HWaddr
00:14:4F:78:4D:64<br />
UP BROADCAST
RUNNING SLAVE MULTICAST MTU:1500 Metric:1<br />
RX packets:516
errors:0 dropped:0 overruns:0 frame:0<br />
TX packets:388
errors:0 dropped:0 overruns:0 carrier:0<br />
collisions:0
txqueuelen:1000<br />
RX bytes:64012
(62.5 KiB) TX bytes:80977 (79.0 KiB)<br /> <br /> ---<br />Will Y.<br />--
<br />This message has been scanned for viruses and
<br />dangerous content by
<a href="http://www.mailscanner.info/"><b>MailScanner</b></a>, and is
<br />believed to be clean.