----- Original Message -----
Have no problems with uncompress it just want to use installer iso
image but
can't understand where I must put iso image (write to USB? or it can be
writed to SD card, installer loads in RAM so I can use installation source
as destination source?)
The script is for deploying the disk images. To do an actual installation on the
rpi3 you would need to run a tftp server and pxe boot. Anaconda requires more than
1G RAM for a network install, so you will also need to nfs mount the squashfs.
If you dont want to go through the pain of setting up the tftp server, you can
likely hack up a minimal usb stick with the kernel/initrd and squashfs from
the installation repo and a custom extlinux.conf pointing to the repo in the apend
line. In either case you will need a mSD with the firmware and U-boot and install
to USB attached disk.
Paul
> _______________________________________________
> arm mailing list -- arm(a)lists.fedoraproject.org
> To unsubscribe send an email to arm-leave(a)lists.fedoraproject.org
>