On Fri, Mar 23, 2018 at 11:28 AM, Tomáš Frolík <tomas.frolik2(a)gmail.com> wrote:
I am a fan Fedora project and Raspberry, too, I have a whole new
piece RPi 3+ in the drawer for only a few days. Nevertheless, there is no functional
combination RPi 3+ and Fedora. I will be excited when it will be ready to use. Can you
here indicate the functional image is released when it will happen?
Everything is in Fedora 28+ now.... well almost. The 4.16rc6 kernel
has a bootable DT, that's not yet in the F-28 nightly images though
due to the beta freeze.
There's all the bits in the firmware/u-boot though. So on a F-28
nightly image if you set a card up as per usual for a Raspberry Pi 3
and then do one other command it'll boot.
Once you've set up the card all you have to do is copy the RPi3 DT to
a 3plus DT and it'll do an initial boot. Once it's booted you can then
just upgrade the kernel and it'll be fine moving forward.
On ARMv7 basically do the following:
cp <BOOT mount point>/dtb-kernel-4.16.0-0.rc4.git0.1.fc28/bcm2837-rpi-3-b.dtb
<BOOT mount point>/dtb-kernel-4.16.0-0.rc4.git0.1.fc28/bcm2837-rpi-3-b-plus.dtb
cp <BOOT mount
Unmount boot and continue as usual.
Once it's running if you update the kernel to rc6 you should be
running just fine. One other thing to note is there's some different
bits needed for the wifi. I'm going to put all of those, inc the one
needed for the original Pi3, into an rpm but I've not had a chance to
do that as yet. Give me a day or so and I'll likely get that done.