[fedora-arm] Re: F30 aarch64 image does not work on Raspberry Pi 3
Hi Jos,
I tried the minimal image[1] with the following command, and it works
fine for me via serial console (I did not attach HDMI output to my RPi3.
Instead I have serial connected). The configuration wizard shows in
serial console as expected, and after I config it I can access my RPi 3.
# sudo fedora-arm-image-installer --addconsole --resizefs --image
Fedora-Minimal-30-1.2.aarch64.raw.xz --media /dev/mmcblk0 --target rpi3
Consider RPi3 do not have a lot of memory, and GNOME is memory hungry, I
would suggest you to try minimal image, or some other lighweight desktop
environment.
HTH.
[1]
https://download.fedoraproject.org/pub/fedora-secondary/releases/30/Spins...
On 8/24/19 7:13 PM, Jos Vos wrote:
Hi,
After consulting https://fedoraproject.org/wiki/Architectures/ARM/Raspberry_Pi
I wrote the raw image found in
https://dl.fedoraproject.org/pub/fedora-secondary/releases/30/Workstation...
on a 16 GB SD card, resized p3 with parted, did a resize2fs (all this
seemed to work fine) and I booted the Pi 3 with it.
It seemed to boot fine, I saw I saw many screens with logging and OK's,
but the last message is "Started GNOME Display Manager" resulting in
nothing else, only followed by occassional audio error messages
("bcm2835_audio: vhci message timeout, msg=3") that are probably not
related.
During the boot I saw a few times an X arrow cursor on a black screen
(that was not reacting to mouse movements BTW).
With ALT-Fx I also have console logins, but root asks for a password
that I don't know.
Any suggestions? Is this supposed to work?
Or should I have a better chance when trying the F31 devel version I see in
https://dl.fedoraproject.org/pub/fedora-secondary/development/31/Workstat...
?
Thanks,
--
Zamir SUN
GPG : 1D86 6D4A 49CE 4BBD 72CF FCF5 D856 6E11 F2A0 525E
Want to know more about Fedora?
Visit https://fedoraproject.org/wiki/
Ready to contribute? See https://whatcanidoforfedora.org/
想了解更多中文资讯，访问 https://zh.fedoracommunity.org/