Raspberry Pi Fedora Remix 18 v5 RC1

[Andrew Greene]

Greetings,

Fellow arm members I am just sending out a quick update to let everyone know that the rpfr-f18-rc1 v5 release is available. As always special thanks to everyone who contributed to help put this together.

v5 Image:
http://scotland.proximity.on.ca/raspberrypi/raspberrypi-fedora-remix/18/imag...

Also please don't forget to file bugs regarding this release here:
http://trac.proximity.on.ca/projects/rpfr/report

[carlos p.]

Hi Andrew,

Great going. It looks like it's working well. Under some load, I notice lots of these in dmesg:

[11551.086853] mmc0: missed completion of cmd 18 DMA (512/512 [1]/[1]) - ignoring it
[11551.086927] mmc0: DMA IRQ 6 ignored - results were reset

The SD card is new and should be decent quality (Sony brand). Will try with another card tomorrow.

(Incidentally, I had a dumb question about the root password, though I eventually figured it out -- it was raspberrypi, iirc. The wiki page says fedoraarm.)

Are there any specific areas to cover testing?

Thanks and great job.

Carlos

________________________________
 From: Andrew Greene 
To: "[e-mail]"  
Sent: Monday, February 11, 2013 8:58 PM
Subject: [fedora-arm] Raspberry Pi Fedora Remix 18 v5 RC1

Greetings,

Fellow arm members I am just sending out a quick update to let everyone know that the rpfr-f18-rc1 v5 release is available. As always special thanks to everyone who contributed to help put this together.

v5 Image:
http://scotland.proximity.on.ca/raspberrypi/raspberrypi-fedora-remix/18/imag...

Also please don't forget to file bugs regarding this release here:
http://trac.proximity.on.ca/projects/rpfr/report

_______________________________________________
arm mailing list
[e-mail]
https://admin.fedoraproject.org/mailman/listinfo/arm

[Tom Callaway]

On 02/11/2013 11:58 PM, Andrew Greene wrote:
> Greetings,
>
> Fellow arm members I am just sending out a quick update to let everyone
> know that the rpfr-f18-rc1 v5 release is available. As always special
> thanks to everyone who contributed to help put this together.
>
> v5 Image:
> http://scotland.proximity.on.ca/raspberrypi/raspberrypi-fedora-remix/18/imag...

Thanks! But what is the status on a more rpi optimized release?
Specifically, armv6 hard-float?

~tom

==
Fedora Project

[Jon Ciesla]

On Sun, Feb 17, 2013 at 10:26 PM, Tom Callaway  wrote:
> On 02/11/2013 11:58 PM, Andrew Greene wrote:
> > Greetings,
> >
> > Fellow arm members I am just sending out a quick update to let everyone
> > know that the rpfr-f18-rc1 v5 release is available. As always special
> > thanks to everyone who contributed to help put this together.
> >
> > v5 Image:
>
> http://scotland.proximity.on.ca/raspberrypi/raspberrypi-fedora-remix/18/imag...
>
> Thanks! But what is the status on a more rpi optimized release?
> Specifically, armv6 hard-float?
>
> ~tom
>
> ==
> Fedora Project
> _______________________________________________
> arm mailing list
> [e-mail]
> https://admin.fedoraproject.org/mailman/listinfo/arm

Also, not sure if this is better suited to a new thread, but I just noticed
this:

http://scotland.proximity.on.ca/raspberrypi/raspberrypi-fedora-remix/18/imag...

Is this the final f18 rpi release?

-J