6:10 p.m.
jberkus reported a new issue against the project: `atomic-wg` that you are following:
``
1. wrote Fedora-Atomic-ostree-x86_64-26-20171003.0.iso to usb key (used in prior tests)
2. ran kickstart install of Atomic using my standard f26 kickstart
3. install ran
4. On rebook, system goes through bootup messages and dmesg for around 20 seconds, then
without warning reboots. This cycle continues as long as I let it (I counted 5 cycles,
then turned it off).
5. Tested with a new USB key and a different minnowboard. Same result.
``
To reply, visit the link below or just reply to this email
https://pagure.io/atomic-wg/issue/345
7:16 a.m.
dustymabe added a new comment to an issue you are following:
``
i'm trying out on my Intel NUC now. Any other tests by anyone with some bare metal
would be appreciated.
``
To reply, visit the link below or just reply to this email
https://pagure.io/atomic-wg/issue/345
7:43 a.m.
dustymabe added a new comment to an issue you are following:
``
i'm trying out on my Intel NUC now. Any other tests by anyone
with some bare metal would be appreciated.
Works fine on Intel NUC - will do another hardware test if we can find some.
``
To reply, visit the link below or just reply to this email
https://pagure.io/atomic-wg/issue/345
9:10 a.m.
sinnykumari added a new comment to an issue you are following:
``
Works fine on Asus Z87-PRO, Intel i7-4770K CPU
``
To reply, visit the link below or just reply to this email
https://pagure.io/atomic-wg/issue/345
9:14 a.m.
miabbott added a new comment to an issue you are following:
``
Tested on a beige box under my desk - AMD Athlon 64 X2 5200+ using BIOS
Also ran a VM install via 'virt-manager' using UEFI.
Both worked fine for me.
``
To reply, visit the link below or just reply to this email
https://pagure.io/atomic-wg/issue/345
9:25 a.m.
dustymabe added a new comment to an issue you are following:
``
seems isolated to minnowboard - in the past we decided to go ahead and release and report
the minnowboard issue upstream to the kernel. I believe we'll probably do the same
here. anyone opposed?
``
To reply, visit the link below or just reply to this email
https://pagure.io/atomic-wg/issue/345
10:59 a.m.
jberkus added a new comment to an issue you are following:
``
+1
``
To reply, visit the link below or just reply to this email
https://pagure.io/atomic-wg/issue/345
11:01 a.m.
jberkus added a new comment to an issue you are following:
``
Of the other bare metal devices people tested, were any UEFI?
If we have a pass on a standard UEFI device, then let's release. If we don't, we
need to test that.
``
To reply, visit the link below or just reply to this email
https://pagure.io/atomic-wg/issue/345
12:13 p.m.
New subject: [atomic-wg] Issue #345: F26: 20171003 ISO does not boot on minnowboard
sinnykumari added a new comment to an issue you are following:
``
Of the other bare metal devices people tested, were any UEFI?
If we have a pass on a standard UEFI device, then let's release. If we don't, we
need to test that.
I tested on Asus Z87-PRO, Intel i7-4770K CPU in UEFI mode and it installs and boots fine.
``
To reply, visit the link below or just reply to this email
https://pagure.io/atomic-wg/issue/345
12:48 p.m.
New subject: [atomic-wg] Issue #345: F26: 20171003 ISO does not boot on minnowboard
dustymabe added a new comment to an issue you are following:
``
my nuc test was on UEFI as well.
``
To reply, visit the link below or just reply to this email
https://pagure.io/atomic-wg/issue/345
7:11 p.m.
New subject: [atomic-wg] Issue #345: F26: 20171003 ISO does not boot on minnowboard
jberkus added a new comment to an issue you are following:
``
1. Installed 9/20 release, which booted fine.
2. rpm-ostree upgraded to the current release. Failure-to-boot behavior continued.
3. rebooted and selected the 9/20 release (26.131)
4. The system continued to fail during bootup.
5. No rollback possible.
This is kind of alarming, we may need to warn users.
``
To reply, visit the link below or just reply to this email
https://pagure.io/atomic-wg/issue/345
7:16 p.m.
New subject: [atomic-wg] Issue #345: F26: 20171003 ISO does not boot on minnowboard
jberkus added a new comment to an issue you are following:
``
Further:
Ok, not a total loss: the system could be rebooted with a cold boot (that is, power off
and back on). For some reason, a hot reboot would not allow you to roll back. But that
means the system is rescueable, and this is less of an alarming issue.
``
To reply, visit the link below or just reply to this email
https://pagure.io/atomic-wg/issue/345
8:57 p.m.
New subject: [atomic-wg] Issue #345: F26: 20171003 ISO does not boot on minnowboard
dustymabe added a new comment to an issue you are following:
``
@jberkus - can you rebase to the updates tree to see if the newer kernel fixes the
problem?
```
rpm-ostree rebase fedora/26/x86_64/testing/atomic-host
```
``
To reply, visit the link below or just reply to this email
https://pagure.io/atomic-wg/issue/345
11:55 p.m.
New subject: [atomic-wg] Issue #345: F26: 20171003 ISO does not boot on minnowboard
jberkus added a new comment to an issue you are following:
``
Well, first, when I switched to testing, I got 26.133. Is that right? Seems like I
should get something later than 26.141.
Second, bootup failed. During the initial soft boot, it failed and stuck with a specific
message:
docker0: link not ready
On subsequent power-cycle boots, it failed the same as 26.141.
``
To reply, visit the link below or just reply to this email
https://pagure.io/atomic-wg/issue/345
8:03 a.m.
New subject: [atomic-wg] Issue #345: F26: 20171003 ISO does not boot on minnowboard
dustymabe added a new comment to an issue you are following:
``
Well, first, when I switched to testing, I got 26.133. Is that
right? Seems like I should get something later than 26.141.
The testing tree and updates tree are separate streams. This just means that we've had
more failures to build in updates-testing than we've had in updates, which makes sense
because testing typically gets the buggy stuff and hopefully it doesn't make it to
stable.
Second, bootup failed. During the initial soft boot, it failed and
stuck with a specific message:
docker0: link not ready
On subsequent power-cycle boots, it failed the same as 26.141.
This tells me its still a problem with the latest kernel. We'll have to file a bug
against the kernel and see what we can find out.
``
To reply, visit the link below or just reply to this email
https://pagure.io/atomic-wg/issue/345
3:16 p.m.
New subject: [atomic-wg] Issue #345: F26: 20171003 ISO does not boot on minnowboard
dustymabe added a new comment to an issue you are following:
``
I'm going to close this out. please re-open if someone finds this is still an issue.
``
To reply, visit the link below or just reply to this email
https://pagure.io/atomic-wg/issue/345
3:20 p.m.
New subject: [atomic-wg] Issue #345: F26: 20171003 ISO does not boot on minnowboard
The status of the issue: `F26: 20171003 ISO does not boot on minnowboard` of project:
`atomic-wg` has been updated to: Closed by dustymabe.
https://pagure.io/atomic-wg/issue/345
2276
days inactive
2397
days old
atomic@lists.fedoraproject.org
16 comments
4 participants
participants (4)
-
Dusty Mabe -
Josh Berkus
-
Micah Abbott
-
Sinny Kumari