https://bugzilla.redhat.com/show_bug.cgi?id=1085245
--- Comment #8 from Oren Oichman <orenoi(a)matrix.co.il> ---
Hi,
I have did some investigation and a notice that the $COLUMNS and $LINES have
changes after I run the bicon command.
if I set them manually then the ncurses application run as it should
me@localhost ~ $ echo $LINES
49
me@localhost ~ $ echo $COLUMNS
140
me@localhost ~ $ bicon
BiCon started
me@localhost ~ $ echo $LINES
24
me@localhost ~ $ echo $COLUMNS
80
is there anything that can be done to preserve the right values ?
thanks in advanced
--
You are receiving this mail because:
You are on the CC list for the bug.
Unsubscribe from this bug
https://bugzilla.redhat.com/token.cgi?t=pLXGMzhW36&a=cc_unsubscribe