Re: Installer…

[David Sastre]

You don't say which hardware, which installation method, or what
documentation you followed, so this is generic help.
(This is documented at
https://docs.fedoraproject.org/en-US/iot/physical-device-setup/)

First, verify the hardware is supported:

$ arm-image-installer --supported

Then write a bootable SD card and power on the device. A serial console is
probably better for troubleshooting.
A different setup procedure is also available:
https://docs.fedoraproject.org/en-US/iot/ignition/

On Thu, May 12, 2022 at 2:55 PM Plummer, Kit <Kit.Plummer(a)gtri.gatech.edu&gt;
wrote:

>  Trying to install Fedora IoT onto some older embedded X86 SBCs.  I
> see the
>  installer launch, and briefly ‘anaconda’ with some output saying the
>  installer is starting.  But then a black/blank screen on my VGA monitor.
>
>  What am I doing wrong?  The docs I’ve seen don’t really show me, even for
>  rPi.
>
>  TIA.
>
>  —-
>  Kit Plummer, Principal Research Engineer
>  GTRI
>  678.741.4734
>  _______________________________________________
>  IoT mailing list -- iot(a)lists.fedoraproject.org
>  To unsubscribe send an email to iot-leave(a)lists.fedoraproject.org
>  Fedora Code of Conduct:
>  https://docs.fedoraproject.org/en-US/project/code-of-conduct/
>  List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines
>  List Archives:
>  https://lists.fedoraproject.org/archives/list/[e-mail]
>  Do not reply to spam on the list, report it:
>  https://pagure.io/fedora-infrastructure
>