On 01/18/18 at 12:32pm, Pingfan Liu wrote:
If ssh-dump with ipv6-target-addr, kdump should wait until the ipv6 addr is ready. Since dracut has implemented this function, we can pass dhcp6 or auto6 in cmdline to activate it. But in 1st kernel, we can not know whether the ipv6 addr is got by dhcp6 or by auto6 without causing side-effect (dhclient -6 will realloc addr). To address it, we take the assumption that if /proc/sys/net/ipv6/conf/$netdev/autoconf is enabled, then the host uses auto6.
Signed-off-by: Pingfan Liu piliu@redhat.com
dracut-module-setup.sh | 6 ++++++ kdump-lib.sh | 12 ++++++++++++ 2 files changed, 18 insertions(+)
diff --git a/dracut-module-setup.sh b/dracut-module-setup.sh index c0f1a88..d1dd673 100755 --- a/dracut-module-setup.sh +++ b/dracut-module-setup.sh @@ -293,6 +293,12 @@ kdump_setup_netdev() { _static=$(kdump_static_ip $_netdev $_srcaddr) if [ -n "$_static" ]; then _proto=none
- elif is_ipv6_address $_srcaddr; then
if is_ipv6_auto $_netdev; then_proto=auto6else_proto=dhcp6 else _proto=dhcp fifidiff --git a/kdump-lib.sh b/kdump-lib.sh index d981c4f..ac4dc67 100755 --- a/kdump-lib.sh +++ b/kdump-lib.sh @@ -310,6 +310,18 @@ is_atomic() grep -q "ostree" /proc/cmdline }
+# fixme, try the best to decide whether the ipv6 addr is allocated by slaac or dhcp6 +is_ipv6_auto() +{
- local _netdev=$1
- local _auto=$(cat /proc/sys/net/ipv6/conf/$_netdev/autoconf)
- if [ $_auto -eq 1 ]; then
return 0- else
return 1- fi
+}
is_ipv6_address() { echo $1 | grep -q ":" -- 2.7.4 _______________________________________________ kexec mailing list -- kexec@lists.fedoraproject.org To unsubscribe send an email to kexec-leave@lists.fedoraproject.org
Pingfan, why we did not see this problem before during test? I remember we talked about this, but I can not recall the reason now.
BTW, does this address the 3 cases we talked about dhcp? Just be curious but with auto first may be fine enough for now.
Thanks Dave
Acked-by: Dave Young dyoung@redhat.com
Thanks Dave