Dear "team" developers and users,

Is it possible to configure VLANs, say: VLAN2 and VLAN3 on top of team with enslaved interfaces say eth0 and eth1, in such a way, that:

1. when only one interface is up, all the traffic goes through that interface;

2. when both interfaces are up, VLAN2 traffic goes through eth0 while VLAN3 traffic goes through VLAN3?

This (requested) behaviour is a little bit similar to the bonding mode 1 - active/backup. The difference is that there is no single "global" active interface, instead each VLAN has its active interface defined irrespective of other VLANs. Looking from the side of enslaved interfeces - any given interface is not definitely in an active or backup state, but rather, for a group of VLANs is active while being in backup state for the other VLANs.

Kind regards,

--

Bartosz Lis

[pl] Instytut Informatyki Politechniki Łódzkiej

[en] Institute of Information Technology, Lodz University of Technology

Wolczanska 215

90-924 Lodz, Poland

phone: +48(42)6312796

fax: +48(42)6303414

email: bartosz.lis@ics.p.lodz.pl