I did a yum upgrade from Fedora 8 to Rawhide and disabled SELinux during
the upgrade just to avoid issues. Now that I finished upgrading, I tried
setting it to on and in enforcing mode.
Relabeling proceeded as expected though seemed slower than usual. After
bootup, I noticed that it says it is in permissive mode. Lots of things
have changed including the init system and I am not sure what to check.
Can someone help me out?
# cat /etc/selinux/config
# This file controls the state of SELinux on the system.
# SELINUX= can take one of these three values:
# enforcing - SELinux security policy is enforced.
# permissive - SELinux prints warnings instead of enforcing.
# disabled - SELinux is fully disabled.
# SELINUXTYPE= type of policy in use. Possible values are:
# targeted - Only targeted network daemons are protected.
# strict - Full SELinux protection.
# SETLOCALDEFS= Check local definition changes
SELinux status: enabled
SELinuxfs mount: /selinux
Current mode: permissive
Mode from config file: error (Success)
Policy version: 22
Policy from config file: targeted
# rpm -qa | grep -i selinux
Show replies by date