On (14/10/19 23:04), Rowan Decker wrote:
Following through the troubleshooting guide and getting stuck on step
Absolutely no output occurs in the sssd log (good or bad) even with [nss] debug_level=6.
Running strace on getent I can confirm that the sss library is getting loaded.
open("/lib64/libnss_sss.so.2", O_RDONLY) = 3
open("/lib64/libnss3.so", O_RDONLY) = 3
open("/lib64/libnssutil3.so", O_RDONLY) = 3
Which command do you test here?
Does nsswitch support modules?
Was "sss" in /etc/nsswitch.conf
Did command try to connect to sssd_nss unix socket?
Looking in the sssd output I can see that the nss responder has
(Thu Oct 10 22:22:50 2019) [sssd[nss]] [sss_process_init] (0x0400): Responder
initialization complete (explicitly configured)
What other steps can be preformed to help debug this issue? We are using a custom
distribution with an older gcc/glibc toolchain with the following configuration.
I am not sure whether prefix="/" is the best "/usr" is usually more
but it should not influence anything if "libnss_sss.so.2" is instaled
on the right location. (but that could be solved with --enable-nsslibdir,