2008/11/30 A.J. Werkman <AJ.Werkman@digifarma.nl>

Installing F10 on an Asus M3N motherboard is not possible in graphics mode. Anaconda falls back to text mode.

Also after installation in runlevel 5 it does not start in grafic mode.

My video is:
02:00.0 VGA compatible controller: nVidia Corporation Device 084d (rev a2) (prog-if 00 [VGA controller])
Subsystem: ASUSTeK Computer Inc. Device 82e8
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0
Interrupt: pin A routed to IRQ 5
Region 0: Memory at fb000000 (32-bit, non-prefetchable) [size=16M]
Region 1: Memory at d8000000 (64-bit, prefetchable) [size=128M]
Region 3: Memory at e6000000 (64-bit, prefetchable) [size=32M]
Region 5: I/O ports at bc00 [size=128]
[virtual] Expansion ROM at e0000000 [disabled] [size=128K]
Capabilities: [60] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [68] Message Signalled Interrupts: Mask- 64bit+ Count=1/1 Enable-
Address: 0000000000000000 Data: 0000
Kernel modules: nvidiafb
00: de 10 4d 08 07 01 10 00 a2 00 00 03 00 00 00 00
10: 00 00 00 fb 0c 00 00 d8 00 00 00 00 0c 00 00 e6
20: 00 00 00 00 01 bc 00 00 00 00 00 00 43 10 e8 82
30: 00 00 00 00 60 00 00 00 00 00 00 00 05 01 00 00

Please advice: can I get this working by manually changing config files or is this VGA adapter not supported?

Koos.

--
fedora-test-list mailing list
fedora-test-list@redhat.com
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-test-list