Mario Gomes (mgomes@eol.ca) said:
I've installed Severn onto a Shuttle SK41G. Below are the specs for the motherboard taken from the Shuttle website:
FX41 CPU Socket : AMD Socket A, support 266/200MHz FSB CPU Chipsets : North bridge-VIA KM266, South bridge-VIA 8235 Memory : Spoort DDR 266/200 * 2 On Board VGA : VIA Savage8, 8-32 MB VGA share memory On Board Audio : Realtek ALC650 support 5.1 channel audio, Support n/Out Expansion Slot : PCI * 1, AGP * 1 IDE interface : ATA-133
I was able to install Severn in text mode to the point that the computer reboots. The problem arises when the reboot is processing, eventually the screen goes blank and I get this error message:
out of range 26Hz / 21Khz
I suspect that the monitor frequency is incorrectly set and I somehow need to change this before the system starts loading. The monitor I have is a GEM LCD and the frequency recommended is (H) 30Khz-60Khz and (V) 50Hz-75 Hz. I would appreciate if someone has any suggestions on how to correct this problem.
If you boot with 'nogui', and then try to start X, is that when it goes out of spec?
Bill