Hi Steven,<br><br><div class="gmail_quote">On Fri, May 28, 2010 at 16:59, Steven P. Ulrick <span dir="ltr">&lt;<a href="mailto:lists-fedora@afolkey2.net">lists-fedora@afolkey2.net</a>&gt;</span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex;">
Hello Everyone,<br>
If the output of &quot;/sbin/lspci | grep VGA&quot; is:<br>
03:00.0 VGA compatible controller: nVidia Corporation G94 [GeForce 9600 GT] (rev<br>
a1)<br>
<br>
are the correct instructions for installing the proprietary NVidia driver still<br>
located here:<br>
<a href="http://fedorasolved.org/video-solutions/nvidia-yum-kmod" target="_blank">http://fedorasolved.org/video-solutions/nvidia-yum-kmod</a><br>
<br>
I have tried the above referenced instructions a couple of times, with the same,<br>
bad results...  I am now going to try again, paying special attention to the<br>
&quot;Troubleshooting&quot; section...  With this exact system, I have been so used to<br>
everything working (up until I installed Fedora 13) that I have never even had<br>
to look at the troubleshooting  steps for these instructions before.<br>
<br>
I will get back to you with whatever happens.<br></blockquote><div><br></div><div>I have a 9800 GT, and all I had to do for F13 was enable rpmfusion repo and install kmod-nvidia; after that Nvidia driver was already used on the next boot, but it didn&#39;t recognize my dual-head setup (which was expected). I tried using nvidia-settings (as root) to configure dual-head, but I had some trouble setting it exactly the way I wanted; then I just replaced /etc/X11/xorg.conf with the one from my F12 /etc backup and that was it. Much easier than with F12 =)</div>
<div><br></div><div>HTH</div><div><br></div><div>Andre</div></div>