On 2/19/19 12:20 PM, Howard Howell wrote:
I did a clean install of F28. Couldn't get the upgrade to work!! So I don't think it would be old extensions, but then I do a lot of development work and get loads of stuff downloaded from time to time installing the bits I need, and some of that may have imported old stuff.
Even with extensions disabled, there were still lots of stack traces. I think it's getting better in F29.
Should I add the printer using the cups 631 interface or the settings panel? The settings panel just threw me off today when I was attempting to answer your first message.
If Gnome settings is crashing your session, you should figure that out. You can add printers using the system-config-printer tool as well. That's usually what I use.
After seeing the cruft in journalctl, I did a journalctl reset and set it to just keep 2 days worth. I may want to up that later.
Unless you're running out of disk space, why limit it?
/************************* finger stuff ************************** $finger print reader daemon
You just found the "finger" command. I haven't used that since university. :-) You can ignore the fprintd log lines.