Am Mi, den 08.12.2004 schrieb David Fletcher um 20:54:
On Tuesday 07 Dec 2004 10:27 pm, Alexander Dalloz wrote:
What does "netstat -talpen | grep perl" on the webmin host print out? What webmin do you run? How is it installed? Did you customize it's setup? Check the content of /etc/webmin/miniserv.conf, especially for being bound to a specific IP.
Alexander
It prints out this:- tcp 0 0 0.0.0.0:10000 0.0.0.0:* LISTEN 0 5992 2227/perl
(I've taken out most of the spaces to make it fit on the line)
So it properly listens.
It's not just webmin that doesn't work via the LAN. I can ssh from FC3 to RH9, but it just doesn't respond the other way.
Dave
I must confess I am run out of suggestions. Last one: run tcpdump to analyze what's going on. Before, check all device settings like IP address and netmask, check ifconfig for error numbers or else unusual values, check the routes, change switch/hub ports.
Alexander