Sudhir Khanger sudhir@sudhirkhanger.com writes:
On Thursday, May 29, 2014 02:19:55 PM lee wrote:
Sudhir Khanger sudhir@sudhirkhanger.com writes:
On Wednesday, May 28, 2014 08:24:09 PM lee wrote:
The built-in dedicated graphics card is not used but not switched off, either. The resulting power drain would make it impossible to complete the installation on battery power.
Because the dual graphic card support came in later Kernels than the one shipped with Fedora 20.
Hm, are such cards going to be supported soon? So far, I haven`t been able to use it at all because when I switch, there is no output to the screen anymore.
Recent Kernels do support power management to turn off dedicated graphic cards. It being able to automagically switch graphic card for GPU load is a long shot at the moment.
If would already help if I could switch manually.
Nouveau doesn't even work on my system. It floods my system with messages [1] which makes it impossible to get to the desktop. I use Nvidia binary drivers through Bumblebee which works fine.
It`s some ATI card in this case. Perhaps the drivers would work, but there won`t be any point when nothing is displayed ...
More importantly, the system doesn`t boot. Any ideas how to install Fedora with the setup I described so that it boots, or how to get it to boot?
The docs tell me it is quite possible to create RAID partition using Anaconda.
http://docs.fedoraproject.org/en-US/Fedora/20/html/Installation_Guide/Create...
http://docs.fedoraproject.org/en-US/Fedora/17/html/Installation_Guide/Create...
It was possible to create them --- or least to tell the installer to do so. Since it doesn`t boot, I don`t know what was actually done.
Why is LVM a default "Partition scheme" (whatever that means)? I have no use for lvm.
Let`s say "I want more space" ... and "Standard Partition" (whatever that is) and "Encrypt my data and set a passphrase later".
Why do you want to use RAID-1 when you say that you have no idea what LVM or even Standard Partitions are?
I`m not saying that I have no idea what LVM is, only that I don`t have use for it. And the installer doesn`t say what it means by "standard partitions". I want to use raid because I don`t store data on a single disk only.
And same goes for employing full-disk encryption. If you don't know what to do with passphrase, you will inevitably use your data permanently and blame Fedora.
I`m not saying that I don`t know what to do with it. Why do I have to enter the passphrase like 10 times? Why does the installer want to save it, and where?
Anyway, I want to use the system. Since Fedora fails and there aren`t any ideas about getting it to work, it seems I have to install something else.