On Thu, 27 Apr 2006, Rob wrote:
Hello,
I have a cluster, master + 8 nodes, connected via a Netgear Gigabit Ethernet Switch (model JGS516).
The cables are of CAT5 type. Elsewhere I read that for a gigabit network, one should use CAT6 type cables, to avoid bad transmissions. Is that so?
Not really. The symbol rate for gigabit ethernet is actually the same as 100Mb/s ethernet, (125mhz) and should run for similar distances over the same cable. using "better cable" buys you squat if your bit-error rate is currently zero...
I already have done basic speed checks, that indicate a throughput of about 0.5 Gbps. Hence the network appears to operate on half of its spec. speed.
Question 1: Should I worry about this reduced speed?
Are your cards in 32 bit 33mhz pci slots?
In general that's about what you can expect without careful selection of the hardware involved.
Question 2: How to check the transmission quality?
Do you see errors in any significant rate on any of your interfaces? Duplex mismatches are rare with gigabit ethernet,
Should I inspect the output of "/sbin/ifconfig eth0" for errors/dropped/overruns/collisions etc. in the RX/TX lines?
If your error rates increment rapidly while sending data then yeah you may have an issue there.
Lan card info: master: Tigon3 10/100/1000BaseT Ethernet tg3: eth0: Link is up at 1000 Mbps, full duplex. tg3: eth0: Flow control is on for TX and on for RX. nodes: Realtek RTL8169 eth0: Auto-negotiation Enabled. eth0: 1000Mbps Full-duplex operation.
Thanks for advice and help! Rob.
Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com