Printer on UPS?
You gotta be joking. Computers and switches OK.
But printers will empty your batteries in moments.

From: "Roger Heflin" <rogerheflin@gmail.com>
Date: Tuesday, 6 October 2020 at 19:03:01
To: "Community support for Fedora users" <users@lists.fedoraproject.org>
Subject: Re: Slow down problem

And on top of what George says, it might be best to make sure the
printer is on the same breaker/120Leg as the computer.

If the computer is on a UPS and the printer is not then if possible
make sure the printer is plugged into the same outlet as the UPS.
Also note that I don't know which power system you are on, I am
familiar with the US hot/neutral/ground 3-prong plug which is supposed
to just work for this, but there are a number of mis-wirings (of both
the outlet and the device) that are common enough to not be unlikely.
 In the US there are simple <$10 devices (most hardware stores) that
plug into outlets and light up and tell you if the outlets are wired
correctly.

Weird ground issues produce really odd behavior.  If everything
involved is using a proper ground outlet and the outlets are properly
ground and all of the devices are properly wired then you should not
have a weird ground issue, which is what this sounds like, and was why
Geroge mentions running a wire to make sure the ground is right.   If
you have a multimeter you could check resistance between a metal part
on the printer and a metal part on the computer without the printer
cable attached, if everything is right the resistance should be almost
0, if the resistance is not almost zero then something really is wired
wrong.  If the resistance is non-zero then there is a decent chance
that the ground on one device vs the other could be a few volts
difference (you can also check that with the meter, but it may or may
not be different enough at the moment), with a small amount it will
think there is a signal when there is not, and with a larger
difference any electronics (the parallel port card) may burn because
there is current flowing were it is not designed to flow.

On Tue, Oct 6, 2020 at 10:46 AM George N. White III <gnwiii@gmail.com> wrote:
>
> On Tue, 6 Oct 2020 at 03:03, ToddAndMargo via users <users@lists.fedoraproject.org> wrote:
>>
>> On 2020-10-05 19:20, Tim via users wrote:
>> > On Mon, 2020-10-05 at 17:15 -0700, ToddAndMargo via users wrote:
>> >> I think I am going to replace the parallel port card
>> >> "just because"
>> >
>> > If your parallel port is on a card, then simply removing the card ought
>> > to show whether *it* is the problem.
>> >
>> > Peripherals are a prime area of hardware failure.  When you have two
>> > mains powered devices hooked together, and one or more of them isn't
>> > earthed, or you connect them together while the equipment is on, it's
>> > very easy to zap components.  They mayn't die instantly, but can be
>> > weakened.
>> >
>> > Peripherals connected between buildings, or even between rooms, also
>> > suffer the same kind of risk.
>>
>> It decides when to poop out.  It is not all
>> that easy to reproduce.
>>
>> Basically, it poops out when I need it the most.
>
>
> Run a wire (at least 18 gauge) from the chassis of the PC to the chassis of the printer.
> This should greatly reduce the chances for the parallel port getting zapped.   You might
> also think about using a more modern interface, with USB to parallel converter or adding
> a network interface to the printer and disposing of the parallel port.
>
>
> --
> George N. White III
>
> _______________________________________________
> users mailing list -- users@lists.fedoraproject.org
> To unsubscribe send an email to users-leave@lists.fedoraproject.org
> Fedora Code of Conduct: https://docs.fedoraproject.org/en-US/project/code-of-conduct/
> List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines
> List Archives: https://lists.fedoraproject.org/archives/list/users@lists.fedoraproject.org
_______________________________________________
users mailing list -- users@lists.fedoraproject.org
To unsubscribe send an email to users-leave@lists.fedoraproject.org
Fedora Code of Conduct: https://docs.fedoraproject.org/en-US/project/code-of-conduct/
List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines
List Archives: https://lists.fedoraproject.org/archives/list/users@lists.fedoraproject.org

Dit bericht kan informatie bevatten die niet voor u is bestemd. Indien u niet de geadresseerde bent of dit bericht abusievelijk aan u is toegezonden, wordt u verzocht dat aan de afzender te melden en het bericht te verwijderen. De Staat aanvaardt geen aansprakelijkheid voor schade, van welke aard ook, die verband houdt met risico's verbonden aan het elektronisch verzenden van berichten.

This message may contain information that is not intended for you. If you are not the addressee or if this message was sent to you by mistake, you are requested to inform the sender and delete the message. The State accepts no liability for damage of any kind resulting from the risks inherent in the electronic transmission of messages.