Found another error too the system logger
is not being started when the kernel does it’s thing. I had Dad go in
to the system log in Gnome with a crash. It said that system logger had crashed.
That was the exact message.
From:
fedora-list-bounces@redhat.com [mailto:fedora-list-bounces@redhat.com] On Behalf Of Scott Berry
Sent: Thursday, May 31, 2007 10:07
PM
To: '
Subject: RE: problem with post
install of Fedora when booting up to Gnome
I already disabled the serial port.
Where the problem I thought lied and that did not work. As far as
everything else it works beautifully.
Scott
From:
fedora-list-bounces@redhat.com [mailto:fedora-list-bounces@redhat.com] On Behalf Of Zachary Napora
Sent: Thursday, May 31, 2007 9:58
PM
To:
Subject: Re: problem with post
install of Fedora when booting up to Gnome
Does the computer have a
PCMCIA card? And are there any other unusual problems with certain hardware,
network interface works and everything? Unless something strange happened and
it's conflicting, all odds are on that it's a hardware problem, personally I'd
start by disabling unnecessary devices and see if it resolves.
On 5/31/07, Scott
Berry <sberry@northlc.com>
wrote:
Hello guys and gals,
My father's computer boots up to Gnome just fine after he enters his
password and username then it creates an error in tty1. The error
says:
Localhostlogin: Serial 8250: Too much work for irq 16. It appears 4
times.
I am assuming here something needs to be shut off but what is is it and how
would you do it?
Scott
--
fedora-list mailing list
fedora-list@redhat.com
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list