On Sat, 2005-10-01 at 02:34, THUFIR HAWAT wrote:
On 9/27/05, Mike McCarty mike.mccarty@sbcglobal.net wrote: ...
The problem is that I don't really know what the problem, the hub itself might be fine. It's guesswork and trial and error.
...
In that case, build/purchase a crossover cable. Then you'll *know*
...
Well, I went out and bought a switch, fifteen canadian dollars, and plugged the Asus WL-330g adapter into the switch, reset and configured the adapter, and everthing works fine now.
So, unless my "experiment" is flawed, the problem was definitely the old hub. I'm curious, however, as to why the old hub failed. According to the manual a hub should work fine.
Aside from pings, how else can you test a hub?
-Thufir
This may have already been suggested but most hubs by default run at 10Mb half duplex. Did you verify using ethtool or mii-tool that your interfaces were running at the correct speed an duplex settings?
Mute now that you have a switch. But just a thought.