On 12/24/15 07:37, Suvayu Ali wrote:
You "have a booting F23 system," do you have a usable desktop display? I have followed the jonarcher procedure several times but always wind up with a nice XFCE desktop display but no keyboard or mouse control, it just does nothing at that point. I have been trying each time I see something encouraging written about it but without success and have pretty much given up hope for the RPI2b and Fedora ...
I am using the minimal image, so no, I do not have a desktop. But I do have a working keyboard and ethernet.
.
The minimal image was the first thing I tried and that worked well enough so then I a "more complete" install and that's where my problems began ...
Did firstboot run for you? If not, that would explain the issue for you.
.
Not sure about "first boot," it's been a few months since I did anything with it, a birthday gift last April. I even forget if I lat put F22 or 23 on it but it works fine until I enter startxfce or whatever it wants, then as I said I get a nice presentation but can't input anything.
I'm having trouble getting wireless to work though. I know my adapter works with the RPi since I have another RPi running OSMC using the same adapter without issues. I tested the adapter with my laptop running F22, that worked nicely. So I know it also works with Fedora x86_64. However it fails to work on the RPi with Fedora ARM. I checked the respective module is loaded 8192cu, although I do not see any rtlwifi. Trying to load it with modprobe gives me a module not found error.
It seems to me, the fedora kernel is not running. Any ideas how I can get it to run?
.
Doesn't that install procedure substitute another kernel, from Pidora perhaps?
I only used the ethernet connection to my LAN. Don't usually use wireless.
There is an ARM list and it is quite active, mostly the developer/testers.
Bob
Cheers,
-- Suvayu