Re: can i completely delete and recreate my network interfaces?
Robert P. J. Day wrote:
let's see if i can make a long story short. for the sake of
sheer
experimentation, i wanted to see if i could *totally* remove all
networking configuration from a gateway laptop running F8 x86_64, then
use system-config-network (henceforth, s-c-n) to recreate it from
scratch.
the underlying hardware (from lspci):
...
02:00.0 Ethernet controller: Marvell Technology Group Ltd. 88E8036
PCI-E Fast Ethernet Controller (rev 10)
...
08:07.0 Network controller: Broadcom Corporation BCM4318 [AirForce One
54g] 802.11g Wireless LAN Controller (rev 02)
...
so i went into s-c-n, removed all traces of network configuration
under both the Devices and Hardware tabs, saved that, removed the
lines from /etc/modprobe.conf:
alias eth0 sky2 (um ... i think that's what it was)
alias wlan0 b43 (added previously by me for wireless)
i then unloaded the above modules from the system, and verified that
the directory /etc/sysconfig/networking/devices is utterly empty. so
... should i be able to put stuff back?
if i invoke s-c-n again, i'm not surprised to see both the Devices
and Hardware tabs totally empty. so how could i recreate the wired
interface eth0? if i try to add a new device of type "Ethernet
Connection", i'm given only a choice of "Other Ethernet Card", and i
don't see a corresponding entry for that ethernet controller. should
i? or am i going about this the wrong way? what would be the correct
recipe to restore my eth0 interface?
i have just as little success trying to restore the wlan0 wireless
interface, *until* i add the line
alias wlan0 b43
back to /etc/modprobe.conf, at which point restoring the wireless
interface via s-c-n is a piece of cake (it even handles the access
point's WEP).
so wireless is back, but still no wired interface eth0, although i'm
puzzled that the directory /etc/sysconfig/networking/devices now
contains three files:
ifcfg-eth0
ifcfg-wlan0
keys-wlan0
and ifcfg-eth0 contains:
# Intel Corporation PRO/100 VE Network Connection
DEVICE=eth0
BOOTPROTO=dhcp
HWADDR=00:E0:B8:BF:7C:3F
ONBOOT=yes
TYPE=Ethernet
so what have i messed up? is there, in fact, any way to restore
eth0? thanks.
I think you need to reboot.
--
Cheers
John
-- spambait
1aaaaaaa(a)coco.merseine.nu Z1aaaaaaa(a)coco.merseine.nu
-- Advice
http://webfoot.com/advice/email.top.php
http://www.catb.org/~esr/faqs/smart-questions.html
http://support.microsoft.com/kb/555375
You cannot reply off-list:-)