link status for 3Com ethernet in fc4?

[sean darcy]

Where do I find the link status - 10mps, 100mps, 
half-duplex, duplex, etc -  for a 3Com ethernet adapter in fc4.

I have two adapters on this machine, eth1 is the 3Com. dmesg 
shows:

.......................
8139too Fast Ethernet driver 0.9.27
eth0: RealTek RTL8139 at 0xfc00, 00:48:54:8b:ab:29, IRQ 11
eth0:  Identified 8139 chip type 'RTL-8139B'
3c59x: Donald Becker and others. 
www.scyld.com/network/vortex.html
0000:00:0f.0: 3Com PCI 3c595 Vortex 100baseTx at 0xff80. 
Vers LK1.1.19
0000:00:0f.0: Overriding PCI latency timer (CFLT) setting of 
64, new value is 248.
..............
eth0: link up, 10Mbps, half-duplex, lpa 0x0000
..................
eth1: no IPv6 routers present
eth0: no IPv6 routers present
......


ifconfig doesn't help.

???

sean

[Bob Chiodini]

On Fri, 2005-09-30 at 13:18 -0400, sean wrote:
>  Where do I find the link status - 10mps, 100mps, 
>  half-duplex, duplex, etc -  for a 3Com ethernet adapter in fc4.
>  
>  I have two adapters on this machine, eth1 is the 3Com. dmesg 
>  shows:
>  
>  .......................
>  8139too Fast Ethernet driver 0.9.27
>  eth0: RealTek RTL8139 at 0xfc00, 00:48:54:8b:ab:29, IRQ 11
>  eth0:  Identified 8139 chip type 'RTL-8139B'
>  3c59x: Donald Becker and others. 
>  www.scyld.com/network/vortex.html
>  0000:00:0f.0: 3Com PCI 3c595 Vortex 100baseTx at 0xff80. 
>  Vers LK1.1.19
>  0000:00:0f.0: Overriding PCI latency timer (CFLT) setting of 
>  64, new value is 248.
>  ..............
>  eth0: link up, 10Mbps, half-duplex, lpa 0x0000
>  ..................
>  eth1: no IPv6 routers present
>  eth0: no IPv6 routers present
>  ......
>  
>  
>  ifconfig doesn't help.
>  
>  ???
>  
>  sean
>   
Sean,

Does mii-tool or ethtool work for this device?

Bob...

[sean darcy]

Bob Chiodini wrote:
>  On Fri, 2005-09-30 at 13:18 -0400, sean wrote:
>  
> >Where do I find the link status - 10mps, 100mps, 
> >half-duplex, duplex, etc -  for a 3Com ethernet adapter in fc4. 
............
> >
>  
>  
>  Sean,
>  
>  Does mii-tool or ethtool work for this device?
>  
>  Bob...
>   
Thanks. Both do.

sean