Hi, On a HP ML 110 with this component:
[root@ca1 ~]# lspci 00:00.0 Host bridge: Intel Corporation E7230/3000/3010 Memory Controller Hub (rev c0) 00:1c.0 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express Port 1 (rev 01) 00:1c.4 PCI bridge: Intel Corporation 82801GR/GH/GHM (ICH7 Family) PCI Express Port 5 (rev 01) 00:1c.5 PCI bridge: Intel Corporation 82801GR/GH/GHM (ICH7 Family) PCI Express Port 6 (rev 01) 00:1d.0 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #1 (rev 01) 00:1d.1 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #2 (rev 01) 00:1d.2 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #3 (rev 01) 00:1d.3 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #4 (rev 01) 00:1d.7 USB Controller: Intel Corporation 82801G (ICH7 Family) USB2 EHCI Controller (rev 01) 00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev e1) 00:1f.0 ISA bridge: Intel Corporation 82801GB/GR (ICH7 Family) LPC Interface Bridge (rev 01) 00:1f.1 IDE interface: Intel Corporation 82801G (ICH7 Family) IDE Controller (rev 01) 00:1f.2 IDE interface: Intel Corporation 82801GB/GR/GH (ICH7 Family) SATA IDE Controller (rev 01) 03:00.0 VGA compatible controller: Matrox Graphics, Inc. MGA G200e [Pilot] ServerEngines (SEP1) (rev 02) 04:00.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5721 Gigabit Ethernet PCI Express (rev 21)
when I push the poweroff button or I run poweroff, the system start the shutdown procedure, but when the system is Off, after 2 or 3 seconds it restart! .. and when it is active, some USB device not work property.
Then in order for poweroff machine and do work USB device, i must remove the power cable when the system is shutdown!!....
If I install on this server FC5 all work great.
There is a solution to this problem of FC6?
I have also install on this HP system F7rc2: with this version of Fedora all work fine, but the poweroff via Button Press not work, I have see witch acpid is not installed by default and there is run a new (for me) process called
"hald-addon-acpi: listening on acpi kernel interface /proc/acpi/event"
Is this process that it would have to be taken care to poweroff the system? why do not do it?
Thank for your reply.
On Thu, 2007-05-31 at 13:05 +0200, Dario Lesca wrote:
when I push the poweroff button or I run poweroff, the system start the shutdown procedure, but when the system is Off, after 2 or 3 seconds it restart!
I used to suffer that, with FC3, I think. For one of my computers I had to change APM/ACPI BIOS settings, and play with kernel parameters related to power. Fedora would reboot instead of shutdown, but the halt command in GRUB would shutdown the box. There's different ways of doing a powerdown.
Have a read through: /usr/share/doc/kernel-doc-*/Documentation/kernel-parameters.txt
-
Dario Lesca -
Tim