Hello Ed,
Finally, I made it works, with vnc. remmina. I just did not remember!!!!!!!!!!!!!
Thank for your help.
Regards.
On 05/02/14 08:56, Patrick Dupre wrote:
I remember that I took the control on this machine. but I cannot do it again. Even in the past, I was able to use nomachine, but not anymore.
with remmina, the only thing that I can do is a text session I cannot use the nx, rdp,xdmcp session.
You probably forgot to install remmina-plugins-vnc
I can get: Command xqproxy not found on SSH server
I am surprised that vncviewer does not work. It works very well when I connect to a machine on the same lan
I would not be surprised if another firewall is there....
What do you think about this http://stufs4u.wordpress.com/2014/02/25/install-and-configure-vnc-server-in-... ?
That is a "fairly" good write-up. However, it will not work as written since the instructions don't open port 5910.
I would use vncserver@:0.service, or vncserver@:1.service, vncserver@:2.service, or vncserver@:3.service to keep things in line using the standard ports.
It is confusing, because something is bizare. And I cannot remember what I did last time. I have been through all my messages. But I do not understand!
-- Do not condemn the judgment of another because it differs from your own. You may both be wrong. -- Dandemis -- users mailing list users@lists.fedoraproject.org To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Fedora Code of Conduct: http://fedoraproject.org/code-of-conduct Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines Have a question? Ask away: http://ask.fedoraproject.org
=========================================================================== Patrick DUPRÉ | | email: pdupre@gmx.com Laboratoire de Physico-Chimie de l'Atmosphère | | Université du Littoral-Côte d'Opale | | Tel. (33)-(0)3 28 23 76 12 | | Fax: 03 28 65 82 44 189A, avenue Maurice Schumann | | 59140 Dunkerque, France ===========================================================================