Error booting both Kernel 2.6.14-1.1637 and 2.6.14-1.1644

[Ubence Quevedo]

I get the following error whenever I boot into Kernel 2.6.14-1.1637  
or the just released 2.6.14-1.1644:

Decompressing Linux...done.
Booting the kernel.
PCI: Cannot allocate resource region 4 of device 0000:00:06.0
PCI: Cannot allocate resource region 4 of device 0000:00:08.0
PCI: Cannot allocate resource region 4 of device 0000:01:00.0
PCI: Failed to allocate I/O resource #4:4000@10000 for 0000:00:08.0
PCI: Error while updating region 0000:00:06.0/4 (00001001 != 0000f001)
PCI: Failed to allocate mem resource #1:40000000@c0000000 for  
0000:01:00.0

My system is a AMD Athlon 64 3000+ CPU installed in a Asus K8N4-E  
Deluxe motherboard with an Asus GeForce 6200 PCIe video card.  I also  
have an Intel Pro 100 PCI network card installed.  Has anyone else  
run into this issue?


-Ubence

[Dave Jones]

On Tue, Nov 29, 2005 at 06:29:03PM -0800, Ubence Quevedo wrote:
>  I get the following error whenever I boot into Kernel 2.6.14-1.1637 
>
>  or the just released 2.6.14-1.1644:
>  
>  Decompressing Linux...done.
>  Booting the kernel.
>  PCI: Cannot allocate resource region 4 of device 0000:00:06.0
>  PCI: Cannot allocate resource region 4 of device 0000:00:08.0
>  PCI: Cannot allocate resource region 4 of device 0000:01:00.0
>  PCI: Failed to allocate I/O resource #4:4000@10000 for 0000:00:08.0
>  PCI: Error while updating region 0000:00:06.0/4 (00001001 != 0000f001)
>  PCI: Failed to allocate mem resource #1:40000000@c0000000 for  
>  0000:01:00.0
>  
>  My system is a AMD Athlon 64 3000+ CPU installed in a Asus K8N4-E  
>  Deluxe motherboard with an Asus GeForce 6200 PCIe video card.  I also  
>  have an Intel Pro 100 PCI network card installed.  Has anyone else  
>  run into this issue? 
Can you remove the 'quiet' from the boot command line, and see
what the last few lines it mentions are ?

		Dave

[Ubence Quevedo]

With Kernel 2.6.13-1.1532_FC4, below [snipped from /var/log/Messages]  
is reported at about the time at boot

Nov 29 18:19:46 fc4-64 kernel: NFORCE-CK804: IDE controller at PCI  
slot 0000:00:06.0
Nov 29 18:19:46 fc4-64 kernel: NFORCE-CK804: chipset revision 242
Nov 29 18:19:46 fc4-64 kernel: NFORCE-CK804: not 100% native mode:  
will probe irqs later
Nov 29 18:19:46 fc4-64 kernel: NFORCE-CK804: BIOS didn't set cable  
bits correctly. Enabling workaround.
Nov 29 18:19:46 fc4-64 kernel: NFORCE-CK804: BIOS didn't set cable  
bits correctly. Enabling workaround.
Nov 29 18:19:46 fc4-64 kernel: NFORCE-CK804: 0000:00:06.0 (rev f2)  
UDMA133 controller
Nov 29 18:19:46 fc4-64 kernel:     ide0: BM-DMA at 0xf000-0xf007,  
BIOS settings: hda:DMA, hdb:DMA
Nov 29 18:19:46 fc4-64 kernel:     ide1: BM-DMA at 0xf008-0xf00f,  
BIOS settings: hdc:DMA, hdd:DMA
Nov 29 18:19:46 fc4-64 kernel: hda: ST320011A, ATA DISK drive
Nov 29 18:19:46 fc4-64 kernel: hdb: SONY CD-RW CRX230ED, ATAPI CD/DVD- 
ROM drive
Nov 29 18:19:46 fc4-64 kernel: ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Nov 29 18:19:46 fc4-64 kernel: hdc: ST360020A, ATA DISK drive
Nov 29 18:19:46 fc4-64 kernel: hdd: IC35L080AVVA07-0, ATA DISK drive
Nov 29 18:19:47 fc4-64 kernel: ide1 at 0x170-0x177,0x376 on irq 15
Nov 29 18:19:47 fc4-64 kernel: hda: max request size: 128KiB
Nov 29 18:19:47 fc4-64 kernel: hda: 39102336 sectors (20020 MB) w/ 
2048KiB Cache, CHS=38792/16/63, UDMA(100)
Nov 29 18:19:47 fc4-64 kernel: hda: cache flushes not supported
Nov 29 18:19:47 fc4-64 kernel:  hda: hda1 hda2 hda3

With removing the quiet from grub for both Kernel 2.6.14-1.1637 and  
2.6.14-1.1644, I get the following:

NFORCE-CK804: IDE controller at PCI slot 0000:00:06.0
NFORCE-CK804: chipset revision 242
NFORCE-CK804: not 100% native mode: will probe irqs later
NFORCE-CK804: BIOS didn't set cable bits correctly. Enabling workaround.
NFORCE-CK804: BIOS didn't set cable bits correctly. Enabling workaround.
NFORCE-CK804: 0000:00:06.0 (rev f2) UDMA133 controller
     ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:DMA
NFORCE-CK804 simplex device: DMA disabled
ide1: NFORCE-CK804 Bus-Master DMA disabled (BIOS)
hda: ST320011A, ATA DISK drive
hdb: SONY CD-RW CRX230ED, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hdc: ST360020A, ATA DISK drive
hdd: IC35L080AVVA07-0, ATA DISK drive
ide1 at 0x170-0x177,0x376 on irq 15
hda: max request size: 128KiB
hda: 39102336 sectors (20020 MB) w/2048KiB Cache, CHS=38792/16/63,  
UDMA(100)
hda: cach flushes not supported
  hda:<4>hda: dma_timer_expiry: dma status == 0xff
hda: dma_timer_expiry: dma status == 0xff
hda: dma_timer_expiry: dma status == 0xff
hda: dma_timer_expiry: dma status == 0xff
hda: dma_timer_expiry: dma status == 0xff
.
.
.

Looks like it has something to do with the secondary onboard IDE  
controller?  I'm running FC4_64 if that helps as well.

-Ubence

On Nov 30, 2005, at 09:57 AM, Dave Jones wrote:

>  On Tue, Nov 29, 2005 at 06:29:03PM -0800, Ubence Quevedo wrote:
> > I get the following error whenever I boot into Kernel 2.6.14-1.1637
> > or the just released 2.6.14-1.1644:
> >
> > Decompressing Linux...done.
> > Booting the kernel.
> > PCI: Cannot allocate resource region 4 of device 0000:00:06.0
> > PCI: Cannot allocate resource region 4 of device 0000:00:08.0
> > PCI: Cannot allocate resource region 4 of device 0000:01:00.0
> > PCI: Failed to allocate I/O resource #4:4000@10000 for 0000:00:08.0
> > PCI: Error while updating region 0000:00:06.0/4 (00001001 !=  
> > 0000f001)
> > PCI: Failed to allocate mem resource #1:40000000@c0000000 for
> > 0000:01:00.0
> >
> > My system is a AMD Athlon 64 3000+ CPU installed in a Asus K8N4-E
> > Deluxe motherboard with an Asus GeForce 6200 PCIe video card.  I also
> > have an Intel Pro 100 PCI network card installed.  Has anyone else
> > run into this issue?
>
>  Can you remove the 'quiet' from the boot command line, and see
>  what the last few lines it mentions are ?
>
>  		Dave
>
>  -- 
>  fedora-list mailing list
>  fedora-list(a)redhat.com
>  To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list