[ Sorry, my first reply from yesterday got eaten by the list manager ]
Am Sa, den 01.05.2004 schrieb bit um 19:59:
Using "hdparm -i /dev/hdX", I found out, that both of my
hard drives
run in
udma2, while they are capable of udma5.
PIO modes: pio0 pio1 pio2 pio3 pio4
DMA modes: mdma0 mdma1 mdma2
UDMA modes: udma0 udma1 *udma2 udma3 udma4 udma5
AdvancedPM=yes: disabled (255) WriteCache=enabled
Drive conforms to: ATA/ATAPI-5 T13 1321D revision 1:
I didn't investigat this any further, apart from reading the hdparm
man pages,
but is it advisable to change from udma2 to udma5 in a completely
installed
and configured OS generally (or FC1 in special) ?
Normally the kernel automatically sets the proper transfer rate and mode
automagically. There are just few cases where it makes sense to override
that manually.
I does not only matter for which transaction mode your hard drive is
capable but also which modes the IDE bus controller chip supports. Given
that your motherboard/IDE controller supports UDMA5 too like your hard
drive, then you can change the mode with:0)100MB/sec
hdparm -X69 /dev/hdX
But if your motherboard only supports ATA33 (UDMA2) or you have just a
40pin IDE ribbon cable the change will not happen or change anything.
Sorry for hijacking the thread, but I felt it was kinda
"apropriate".
:-)
No, it is no hijacking, your question just focuses on a specific part of
the original thread. Don't worry ;)
Thanks for any help.
> Alexander
Have phun,
bit
Alexander
P.S. Reading now that it was the wrong cable. One of the factors I
mentioned.
--
Alexander Dalloz | Enger, Germany | GPG key 1024D/ED695653 1999-07-13
Fedora GNU/Linux Core 1 (Yarrow) on Athlon CPU kernel 2.4.22-1.2188.nptl
Sirendipity 13:25:10 up 5 days, 12:13, load average: 0.20, 0.21, 0.17
[ Γνωθι σ'αυτον - gnothi seauton ]
my life is a planetarium - and you are the stars