[Fedora-xen] Problems with Xen + FC5 + Thinkpad
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Hello all,
I recently upgraded from FC4 to FC5 on my Thinkpad T30 laptop and am looking forward to
playing with
Xen. However, I've hit a few stumbling blocks along the way. Following the
instructions at
http://www.fedoraproject.org/wiki/FedoraXenQuickstartFC5
I installed the Xen0 kernel and booted my system with it. However it hangs, seemingly
forever, at
the "Starting xend" stage. The OS seems ok as keypresses are still printed to
the screen, but
because the daemon never completes its startup process the boot sequence never finishes.
Upon
rebooting I noticed an error that gets printed while the kernel is loading, which says
that it could
not bind IRQ2 to guest because it is in use by cascade. This happens consistently, so I
wonder if
it's a hardware problem?
I booted the system into single user mode and chkconfig'd xend off, booted normally
and attempted to
start the daemon post-boot. It printed a message about starting the Bridged Firewall,
which I had
not seen during bootup, but still seemed to hang indefinitely.
Oh, and SELinux is loaded but not enforcing. Should that be sufficient?
Does anyone have suggestions for how I might further troubleshoot this?
Thanks,
- --Brad
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.2.2 (GNU/Linux)
Comment: Using GnuPG with Fedora - http://enigmail.mozdev.org
iD8DBQFEKrcaDvp49DvQ8kcRAv8yAJ0cHBQsP3KwEGb+x9GZTXga6e24/ACeIQG6
MCywwa529LxnXECf2YLo4SI=
=Z3wj
-----END PGP SIGNATURE-----