Re: [Fedora-xen] Re: initscripts, xen and bonding

I'm using Fedora 4 and wound up fixing it manually for now, if we decide 
to keep xen we'll write a boot script to do it.

Basically, both bond0 and pbond0 must be active at the same time, so leave 
your bond0 setup as is. Copy /etc/sysconfig/network-scripts/ifcfg-bond0 to 
ifcfg-pbond0 and rename the Device value (not sure this step is 
necessary).

Reboot and on bootup, do:
sudo ifconfig pbond0 (IP address) network (255.255.255.x) broadcast (your 
address)
sudo ifenslave pbond0 eth0
sudo ifenslave pbond0 eth1

The 3 addresses above are the same as used by bond0.




Axel Thimm <Axel.Thimm(a)ATrpms.net&gt; 
Sent by: fedora-xen-bounces(a)redhat.com
04/20/06 08:15 AM
Please respond to
fedora-xen(a)redhat.com


To
fedora-xen(a)redhat.com
cc

Subject
[Fedora-xen] Re: initscripts, xen and bonding






Hi,

I'm retrying to get bonding and xen working with FC5:

https://bugzilla.redhat.com/bugzilla/show_bug.cgi?id=189473

The summary is that

o xend at boot time does not attach anything to xenbr, the network is
  other than the added broken xenbr unaltered. So at least booting
  into kernel-xen0 doesn't hook you off the wire anymore (as it was
  with FC5t3)

o after calling xend restart the bridge is almost properly set up,
  only the slaves of the bond interface get lost in the process

Anyone know how to fix/workaround these issues?

Thanks!
-- 
Axel.Thimm at ATrpms.net
--
Fedora-xen mailing list
Fedora-xen(a)redhat.com
https://www.redhat.com/mailman/listinfo/fedora-xen