[fedora-arm] Guruplug | uaputl fail

[Bernhard Schuster]

Has anyone stumbled upon uaputl failing to bss_start? Everything else works
as it seems.

[root at fedora-arm home]# uaputl sys_cfg_radio_ctl 0
Radio setting successful
[root at fedora-arm home]# uaputl sys_cfg_channel 5
Channel setting successful
[root at fedora-arm home]# uaputl sys_cfg_ssid "dummyssid"
SSID setting successful
[root at fedora-arm home]# uaputl sys_cfg_protocol 32
protocol setting successful
[root at fedora-arm home]# uaputl sys_cfg_cipher 8 8
cipher setting successful
[root at fedora-arm home]# uaputl sys_cfg_wpa_passphrase "dummypasswd"
WPA passphrase setting successful
[root at fedora-arm home]# uaputl bss_start
ERR:UAP_BSS_CTRL fail, result=0
ERR:Could not start BSS!

ifconfig uap0
      Link encap:Ethernet  HWaddr 00:24:23:1F:B1:7B
      UP BROADCAST MULTICAST  MTU:1500  Metric:1
      RX packets:0 errors:0 dropped:0 overruns:0 frame:0
      TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
      collisions:0 txqueuelen:1000
      RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)

Some uaputl <option> give ERR: not supported "blah".

any ideas?

Note: I compiled a patched kernel (based on vanilla 2.6.34.1) with full
support for libertas_uap, kopied the mrvl firmware folder from the debian
rootfs over to my SDHC card, copied uaputl from the debian rootfs, did
modules_install firmware_install header_install and blacklisted libertas and
libertas_sdio to prevent them hogging the hardware before libertas_uap comes
onto the playfield.

Help is very much appreaciate. If required  I can "send"(torrent or alike)
the full image (~15GiB), the KernelBuild env, uImage and modules.

Thanks for any help or tipps

Regards

Bernhard
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.fedoraproject.org/pipermail/arm/attachments/20100810/766e0588/attachment.html