[fedora-arm] PogoPlug E02 -- 25 bucks.
Scott Sullivan
scott at ss.org
Mon Dec 12 16:31:27 UTC 2011
On 12/12/2011 11:00 AM, Peter Robinson wrote:
> On Mon, Dec 12, 2011 at 3:58 PM,<omalleys at msu.edu> wrote:
>> I received a pogoplug from J&R electronics, for 25 bucks with free
>> shipping (after signing up for their account. limit2 and the deal ends
>> today. It is a pogoplug pink E02 iirc.)
>>
>> I thought it was going to have the oxnas armv6 processor in it, but it
>> ships with the marvell kirkwood. It only has a usb interface and GigE,
>> to get to the serial port or the jtag, you need to pull it
>> apart,(there are no pins on the board for anything else). Im not sure
>> the -exact- specs of it. But I think it is 2gig flash and like 256
>> ram, so not the greatest, but it might be a good test machine or
>> builder for someone doing armv5 work.
That's a version 2 pogoplug, specs below.
http://archlinuxarm.org/platforms/armv5/pogoplug-v2-pinkgray
The armv6 based ones are the Pros and V3 versions.
http://archlinuxarm.org/platforms/armv6/pogoplug-provideov3
I've currently got about 4 of the V2s that I'm working to build up a
small Fedora dev group on. Haven't played with the V3s yet. I've already
added a serial connection one of them. I wired up a JST connector to the
header and brought the lines out the back using a 3.5mm headphone jack.
I then connect a USB to 3.3v UART adapter.
Email me off list if you need the pin outs.
>
> They're basically a guruplug in drag from what I recall.
>
> Peter
Closer to a Sheeva Plug for the V2s.
--
Scott Sullivan
More information about the arm
mailing list