[fedora-arm] Fedora 21 on Olimex Board (A10S)

[Craig Lanning]

I have an A10S-OlinuXino-MICRO board.

I loaded Fedora 20 on it before 21 was available and it worked fine.  It
would use the HDMI monitor as its display.

I tried Fedora 21 on it today.  I followed the F21 installation
instructions that said to write the image to the SD card and then copy
the U-Boot image for the specific card to the appropriate place.  For
the Place I used the same instructions as given for the other A10 and
A20 boards.

This booted up and wrote messages to the serial port.  It ended with a
login prompt.  If I tried to enter a username via the terminal emulator,
nothing happened.  It didn't seem to get any characters.  So I plugged a
USB keyboard into it, but to no avail.  It recognized that I had plugged
a keyboard in, but wouldn't use anything I typed.

Is there additional configuration that I missed?

Craig