[fedora-arm] Can rawhide image boot on Beagle Bone Black?

[Zamir SUN]

Hi team,
I am planning to test Fedora 23 ARM on Beagle Bone black from the early 
image. So I downloaded Fedora-Xfce-armhfp-23-20150715-sda.raw.xz from 
http://koji.fedoraproject.org/koji/taskinfo?taskID=10371084 and flash it 
into a TF card.

During the flashing, I find such error:

= Writing image complete!
= Writing MLO for beaglebone....
dd: failed to open ‘/tmp/root/usr/share/uboot/beaglebone/MLO’: No such 
file or directory
= Writing u-boot.img for beaglebone....
dd: failed to open ‘/tmp/root/usr/share/uboot/beaglebone/u-boot.img’: No 
such file or directory

= Installation Complete! Insert into the beaglebone and boot.
$
And then I just try to boot Beagle Bone Black from the image and find it 
do not work. The serial output is as following:
U-Boot SPL 2014.04-00014-g47880f5 (Apr 22 2014 - 13:23:54)
reading args
spl_load_image_fat_os: error reading image args, err - -1
reading u-boot.img
reading u-boot.img


U-Boot 2014.04-00014-g47880f5 (Apr 22 2014 - 13:23:54)

I2C: ready
DRAM:  512 MiB
NAND:  0 MiB
MMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1
*** Warning - readenv() failed, using default environment

Net: <ethaddr> not set. Validating first E-fuse MAC
cpsw, usb_ether
Hit any key to stop autoboot:  0
gpio: pin 53 (gpio 53) value is 1
mmc0 is current device
gpio: pin 54 (gpio 54) value is 1
SD/MMC found on device 0
** File not found uEnv.txt **
Checking if uenvcmd is set ...

uenvcmd was not defined in uEnv.txt ...
gpio: pin 56 (gpio 56) value is 0
gpio: pin 55 (gpio 55) value is 0
gpio: pin 54 (gpio 54) value is 0
mmc1(part 0) is current device

then it boot to my system on emmc. So am I wrong in some steps? Or the 
image just can not boot up on Beagle Bone Black by design?

Thanks.


-- 
Zamir SUN
zsun at fedoraproject.org
zsun in #fedora-zh #openshift on freenode.net