F15: massive problems with USB3.0

Sun Oct 9 07:47:41 UTC 2011

W dniu 07.10.2011 17:23, Reindl Harald pisze:
> hi
> 
> i have two machines with the same USB3 card and massive problems
> with two different external disks - should this be a bugreport for
> the kernel? i am wondering about this troubles because AFAIK the
> linux-kernel was first with support for USB3 and that 2 different
> disks and/or both controllers are defect is not realistic
> 
> * below after the first connect only an error (2 TB disk)
> * second connect much more errors but device deteced
> * after crash of the usb-controller only reboot let appear any drive again
> * the third output is from anothr device with 500GB
> 
> the 500GB works mostly but had also lost data, the 2 TB drive
> is unusable and data are destroyed (luks-container)
> 
> 2.6.40.6-0.fc15.x86_64 #1 SMP Tue Oct 4 00:39:50
> 02:00.0 USB Controller: NEC Corporation uPD720200 USB 3.0 Host Controller (rev 03)
> ______________________________________________
> 
> usb 4-1: new SuperSpeed USB device number 2 using xhci_hcd
> xhci_hcd 0000:02:00.0: WARN: short transfer on control ep
> xhci_hcd 0000:02:00.0: WARN: short transfer on control ep
> xhci_hcd 0000:02:00.0: WARN: short transfer on control ep
> usb 4-1: New USB device found, idVendor=174c, idProduct=5106
> usb 4-1: New USB device strings: Mfr=2, Product=3, SerialNumber=1
> usb 4-1: Product: AS2105
> usb 4-1: Manufacturer: ASMedia
> usb 4-1: can't set config #1, error -110
> ______________________________________________
> 
> usb 4-1: USB disconnect, device number 2
> hub 4-0:1.0: unable to enumerate USB device on port 1
> usb 4-1: new SuperSpeed USB device number 4 using xhci_hcd
> xhci_hcd 0000:02:00.0: WARN: short transfer on control ep
> xhci_hcd 0000:02:00.0: WARN: short transfer on control ep
> xhci_hcd 0000:02:00.0: WARN: short transfer on control ep
> xhci_hcd 0000:02:00.0: WARN: short transfer on control ep
> usb 4-1: New USB device found, idVendor=174c, idProduct=5106
> usb 4-1: New USB device strings: Mfr=2, Product=3, SerialNumber=1
> usb 4-1: Product: AS2105
> usb 4-1: Manufacturer: ASMedia
> usb 4-1: SerialNumber:      WD-WCAWZ0975740
> scsi9 : usb-storage 4-1:1.0
> scsi 9:0:0:0: Direct-Access     WDC WD20 EARS-00J99B0     80.0 PQ: 0 ANSI: 0
> sd 9:0:0:0: Attached scsi generic sg10 type 0
> sd 9:0:0:0: [sdj] 3907029168 512-byte logical blocks: (2.00 TB/1.81 TiB)
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> sd 9:0:0:0: [sdj] Write Protect is off
> sd 9:0:0:0: [sdj] Mode Sense: 23 00 00 00
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> sd 9:0:0:0: [sdj] No Caching mode page present
> sd 9:0:0:0: [sdj] Assuming drive cache: write through
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> sd 9:0:0:0: [sdj] No Caching mode page present
> sd 9:0:0:0: [sdj] Assuming drive cache: write through
>  sdj: sdj1
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> sd 9:0:0:0: [sdj] No Caching mode page present
> sd 9:0:0:0: [sdj] Assuming drive cache: write through
> sd 9:0:0:0: [sdj] Attached SCSI disk
> sd 9:0:0:0: [sdj]  Sense Key : Recovered Error [current] [descriptor]
> Descriptor sense data with sense descriptors (in hex):
>         72 01 04 1d 00 00 00 0a 09 0c 00 00 00 00 00 07
>         00 00
> sd 9:0:0:0: [sdj]  ASC=0x4 ASCQ=0x1d
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> sd 9:0:0:0: [sdj]  Sense Key : Recovered Error [current] [descriptor]
> Descriptor sense data with sense descriptors (in hex):
>         72 01 04 1d 00 00 00 0e 09 0c 00 00 00 00 00 07
>         00 00 00 00 40 50
> sd 9:0:0:0: [sdj]  ASC=0x4 ASCQ=0x1d
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> sd 9:0:0:0: [sdj]  Sense Key : Recovered Error [current] [descriptor]
> Descriptor sense data with sense descriptors (in hex):
>         72 01 04 1d 00 00 00 0e 09 0c 00 00 00 00 e8 87
>         00 7f 00 e0 40 50
> sd 9:0:0:0: [sdj]  ASC=0x4 ASCQ=0x1d
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> sd 9:0:0:0: [sdj]  Sense Key : Recovered Error [current] [descriptor]
> Descriptor sense data with sense descriptors (in hex):
>         72 01 04 1d 00 00 00 0e 09 0c 00 00 00 00 00 07
>         00 08 00 00 40 50
> sd 9:0:0:0: [sdj]  ASC=0x4 ASCQ=0x1d
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> sd 9:0:0:0: [sdj]  Sense Key : Recovered Error [current] [descriptor]
> Descriptor sense data with sense descriptors (in hex):
>         72 01 04 1d 00 00 00 0e 09 0c 00 00 00 00 00 0f
>         00 08 00 00 40 50
> sd 9:0:0:0: [sdj]  ASC=0x4 ASCQ=0x1d
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> sd 9:0:0:0: [sdj]  Sense Key : Recovered Error [current] [descriptor]
> Descriptor sense data with sense descriptors (in hex):
>         72 01 04 1d 00 00 00 0e 09 0c 00 00 00 00 e8 00
>         00 4f 00 c2 00 50
> sd 9:0:0:0: [sdj]  ASC=0x4 ASCQ=0x1d
> ______________________________________________
> 
> usb 4-1: new SuperSpeed USB device number 6 using xhci_hcd
> xhci_hcd 0000:02:00.0: WARN: short transfer on control ep
> xhci_hcd 0000:02:00.0: WARN: short transfer on control ep
> xhci_hcd 0000:02:00.0: WARN: short transfer on control ep
> xhci_hcd 0000:02:00.0: WARN: short transfer on control ep
> usb 4-1: New USB device found, idVendor=04e8, idProduct=60a3
> usb 4-1: New USB device strings: Mfr=1, Product=11, SerialNumber=3
> usb 4-1: Product: Samsung S2 Portable 3
> usb 4-1: Manufacturer: JMicron
> usb 4-1: SerialNumber: 00000000011E0AC9
> scsi10 : usb-storage 4-1:1.0
> scsi 10:0:0:0: Direct-Access     Samsung  S2 Portable 3    3    PQ: 0 ANSI: 6
> sd 10:0:0:0: Attached scsi generic sg10 type 0
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> sd 10:0:0:0: [sdj] 976752688 512-byte logical blocks: (500 GB/465 GiB)
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> sd 10:0:0:0: [sdj] Write Protect is off
> sd 10:0:0:0: [sdj] Mode Sense: 27 00 00 00
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> sd 10:0:0:0: [sdj] No Caching mode page present
> sd 10:0:0:0: [sdj] Assuming drive cache: write through
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> sd 10:0:0:0: [sdj] No Caching mode page present
> sd 10:0:0:0: [sdj] Assuming drive cache: write through
>  sdj: sdj1 sdj2 sdj3
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> xhci_hcd 0000:02:00.0: WARN: Stalled endpoint
> sd 10:0:0:0: [sdj] No Caching mode page present
> sd 10:0:0:0: [sdj] Assuming drive cache: write through
> sd 10:0:0:0: [sdj] Attached SCSI disk
> 
> 
> 
> 
> 
Hi,

I am also having annoying issues with USB3. It seems like the best place
to get help is linux-usb mailing list.

Julian