Fedora 20 Update: ultimaker2-marlin-firmware-13.11-2.1.fc20

updates at fedoraproject.org updates at fedoraproject.org
Tue Dec 24 03:42:52 UTC 2013

Fedora Update Notification
2013-12-16 06:31:03

Name        : ultimaker2-marlin-firmware
Product     : Fedora 20
Version     : 13.11
Release     : 2.1.fc20
URL         : https://github.com/Ultimaker/SecretMarlin
Summary     : Ultimaker2 firmware for the 3D printer
Description :
Ultimaker2 firmware for the 3D printer.

Update Information:

cura update 13.11.2
* Adjusted the gantry height to 55mm for the Ultimaker, as 60mm was 3mm to high for the default setup with an V2 hotend.
* Added disallowed zones for UM2
* Added ooze-shield for dual-color printing
* Added wipe tower for dual-extrusion
* Added no-go zones for UM2 glass clips
* Added imageToMesh tool to load images as 3D height maps
* Fixed Z support distance when using "everywhere" support.
* Updated to new version of clipper to fix rare slicing bugs that resulted in odd paths.
* Fixed "Reset profile" so it no longer resets the machine settings.
* Updated support material so support is smoother and has less small sections which are hard to remove.
* Fixed start-gcode when using dual-support material
* Change how the fan is handled on lower layer to improve UM2 printing.
* Fix that retraction is enabled when selecting UM2 or RepRap.
* Scale down very large models, or scale up very tiny models automagicly.
* Fixed skirt and brim to go around the support instead of under it.
* Added spiralize mode

Ultimaker2 - Firmware update - 13.11-2
* Fixed UM2 build volume offset so that you do not print off the glass plate.
* Slightly tweaked the filament change procedure so there is less chance of a blob staying behind.
* Slightly tweaked the SD-Card error problems.
* Added LED settings to Tune menu
* Start heating the nozzles when the bed is nearing its final temperature, so the nozzles do not sit hot.
* Make sure all commands are finished before starting a print or changing material. This could cause issues when you where too fast.
* Fixed SD-Card read error
* Added feature to store your own material presets
* Fixed the 280C ABS problem, causing a temperature sensor error


This update can be installed with the "yum" update program.  Use 
su -c 'yum update ultimaker2-marlin-firmware' at the command line.
For more information, refer to "Managing Software with yum",
available at http://docs.fedoraproject.org/yum/.

All packages are signed with the Fedora Project GPG key.  More details on the
GPG keys used by the Fedora Project can be found at

More information about the package-announce mailing list