NM says device not ready when resuming from suspend

[Rodd Clarkson]

On Fri, 2010-04-09 at 10:14 +1000, Rodd Clarkson wrote:
> I'm almost sure that this is going to fall on deaf ears since I have no
> choice but to use the broadcom wl driver (as there's no open source
> alternative) but I'll give it a go because this didn't used to be a
> problem in f13 and isn't a problem in f12, so I regard it as a
> regression.
> 
> When I resume from a suspend, NM in f13 doesn't connect to my wireless
> network.  If you click on the nm-applet, the Wireless Networks section
> says device not ready.
> 
> If I right click and disable and then enable wireless networking then
> all is good and everything works fine.
> 
> This isn't a problem in f12, which just connects to the wireless network
> (I know it's using a different version of NM) and it wasn't a problem
> with NM in f13 until recently.
> 
> What are my chances of getting this addressed?
> 
> I've looked at the b43 driver, but it doesn't support my wireless card
> and there doesn't even seem to be a driver in development for my card at
> this moment (arggh)
> 
> my card is as follows:
> 
> $  lspci -nn | grep Broadcom
> 04:00.0 Network controller [0280]: Broadcom Corporation BCM43224 802.11a/b/g/n [14e4:4353] (rev 01)
> 09:00.0 Ethernet controller [0200]: Broadcom Corporation NetLink BCM5784M Gigabit Ethernet PCIe [14e4:1698] (rev 10)

I'm in luck.  This isn't just my network card.

see: https://bugzilla.redhat.com/show_bug.cgi?id=579202


Rodd