x86_64 "Bad RIP value" on boot
Christopher K. Johnson
ckjohnson at gwi.net
Wed Mar 24 01:15:18 UTC 2004
Andrius wrote:
> First off - I haven't got the entire dmesg, I didn't fancy writing
> (and the
>
>boot didn't get far enough to write to disk - I'm hoping someone has already
>bumped into this and can point me in the right direction.
>
>
I recently had to capture console messages for a boot problem. Check
out the boot parameters/grub, and the getty/agetty parts in the tldp.org
link below. The first was sufficient to get me a log of console
messages from booting the kernel. The latter if you want login access
via serial port after boot. I used minicom on another pc acting as
console, and set to use 15200 n81 no hardware flow control (cts/rts),
then I added the following to boot parameters:
console=tty0 console=ttyS0,115200n8
http://www.tldp.org/HOWTO/Remote-Serial-Console-HOWTO/
--
-----------------------------------------------------------
"Spend less! Do more! Go Open Source..." -- Dirigo.net
Chris Johnson, RHCE #807000448202021
More information about the users
mailing list