Still have problem with sensors-detect -

[Bob Goodwin]

I went through the sensors-detect routine again, accepted all
the defaults and it appears that I may need to install a "driver"
somewhere but "should be inserted" leaves me wondering,
inserted where and how?
             - - - - - - - - - - - - - - - - - - - - - - -
 Now follows a summary of the probes I have just done.
 Just press ENTER to continue:

Driver `adm9240' (should be inserted):
  Detects correctly:
  * Bus `SMBus PIIX4 adapter at 7000' (Algorithm unavailable)
    Busdriver `i2c-piix4', I2C address 0x2d
    Chip `Analog Devices ADM9240' (confidence: 7)

                      - - - - - - - - - - - - -

Apparently the only device detected is an smbus device.

                      - - - - - - - - - - - - -

Probing for `Analog Devices ADM9240'... Success!
    (confidence 7, driver `adm9240')

                      - - - - - - - - - - - - -

Scanning for ISA only, answering no to the smbus scans produces
the message  " Sorry, no chips were detected. "

So I conclude that it's smbus or nothing. With RH-9 I would see
messages relative to the "sensors" at system boot, I don't get
them now.

So do I need to install a "driver" and if so, where and how? I may
still have one on the other hard drive if I knew the file name.

Thank you.

Bob Goodwin   Zuni, Virginia