Ide=nodma is "loosing too many ticks"
Mark
msalists at gmx.net
Mon Apr 4 19:43:53 UTC 2005
Hi Roberto,
> Dear Mark,
>
> I was able to work on my DMA using the article:
> http://www.linuxdevcenter.com/pub/a/linux/2000/06/29/hdparm.html
Thanks for the link I'll check it out...
> What do you meean with the incorrect syncronization onf an SMP system
> and how could I fix this?
> Could you please suggest some changes?
No clue, that was part of the error message I got - I did not write that :)
I still am not sure if this is really a driver problem... It seems to me like my standard Dell box (about 2-3 years old) is really
nothing special, so the drivers should be pretty main-stream... But maybe I'm wrong...
I am also still not sure if this is really a problem or not...
MARK
>
> Roberto
>
> Roberto
>
> Mark wrote:
>
> >I got the following problem after my FC3 install:
> >
> >Losing too many ticks!
> >TSC cannot be used as a timesource.
> >Possible reasons for this are:
> > You're running with Speedstep,
> > You don't have DMA enabled for your hard disk (see hdparm),
> > Incorrect TSC synchronization on an SMP system (see
> dmesg). Falling
> >back to a sane timesource now.
> >
> >
> >I have ide=nodma in the boot parameters, since I was not able to
> >complete the install with that parameter. If I try to take this
> >parameter out of the grub.conf, I get the below and the machine does
> >not boot:
> >
> >hdc: cdrom_pc_intr: The drive appears confused (ireason 0x02)
> >ide-cd: cmd 0x1e timed out
> >hdc: lost interupt
> >
> >I also tried "ide0=dma ide1=nodma" with the same problem (CDROMs are
> >hdc and hdd on ide1) Then I tried "ide=nodma ide0=dma". It
> boots, but I
> >dont know if it fixes the original problem...
> >
> >
> >Should I leave "ide=nodma" in and live with the first
> warning? Is this
> >just a warning that can be ignored or is there something that could
> >actually go wrong if I use this as a production server?
> >
> >I am surprised about this whole "ide=nodma" thing anyway. It
> seems that
> >the only way to get Fedora installed on any of my machines is to use
> >"ide=nodma"as boot params. Sometimes I even seem to need
> "allowcddma".
> >My machines are by no means special, just standard IDE
> controllers with
> >a bunch of IDE HDs and IDE cdrom... What is the best
> practise for this
> >case?
> >
> >
> >Thanks,
> >
> >MARK
> >
> >
> >
> >
>
> --
> Roberto R. Heredia, Ph.D
> Associate Professor of Psychology
> Department of Behavioral, Applied Sciences & Criminal Justice
> Texas A&M International University
> 5201 University Boulevard
> Laredo, Texas 78041-1900
>
> Cognitive Science Laboratory: BH 224
> Phone: (956)326-2637
> Facsimile: (956)326-2474
> mailto:rheredia at tamiu.edu
> http://www.tamiu.edu/~rheredia <http://www.tamiu.edu/%7Erheredia>
>
More information about the users
mailing list