Cable Select vs. Master/slave settings
Claude Jones
claude_jones at levitjames.com
Tue Aug 9 15:23:06 UTC 2005
On Tue August 9 2005 11:10 am, Mike McCarty wrote:
> Claude Jones wrote:
> > On Mon August 8 2005 5:31 pm, Mike McCarty wrote:
> >>............., yet!
> >>
> >>You would lose your bet. I advise against cable select, *ALWAYS*.
> >
> > The operative here is that 'yet' just above your declaration...
>
> Good point! :-)
>
Ok - final point, since you did seem to pull back what from seemed to be
turning into a mud-sling. My experience has been, also after a very long
frustrating diagnostic session on a mission critical pc, that it is possible
to jumper m/s the drives, using a cs cable, and it NOT work - In fact, if
you'd been present during that session, you'd have lost the bet.
There are standards, and there are standards, as you rightly point out, and
much equipment is produced in complete violation of same - now why that
particular instance occurred for me at that time, is lost to history, but it
happened, and was formative in my reaching my current methods of operation.
We only purchase name brand cables here because our business depends on them
and with over 50 pc's to keep running, it's not a luxury to keep out cheap
crap, but a necessity. Poor quality components always cost more in down-time
than we save. So, if a PC comes in with issues I suspect may be jumper/cable
related, I reach for what's in inventory, and I jumper accordingly, per my
previous description of method. For a long time, I too have had no problems
in this area.
--
Claude Jones
Bluemont, VA, USA
More information about the users
mailing list